6
AE-5 SELF DIAGNOSTIC SOFTWARE
The identification of errors within the AE-5 chassis is triggered in one of two ways :- 1: Busy or 2: Device failure to respond to IIC. In the event of
one of these situations arising the software will first try to release the bus if busy (Failure to do so will report with a continuous flashing LED) and
then communicate with each device in turn to establish if a device is faulty. If a device is found to be faulty the relevant device number will be
displayed through the LED (Series of flashes which must be counted) See table 1., non fatal errors are reported using this method.
Flash Timing Example : e.g. error number 3
StBy LED
ON ON ON
OFF
OFF
metIcitsongaiD
noitpircseD
ybdnatSsemitfooN
sehsalFDEL
esuacelbaborP
noitacoL
smotpmySdetceteD
nonruttonseodrewoPthgiltonseoD
.nideggulptonsidrocrewoP
.tiucricneposiesuF
noemoctonseodrewoP
VTehtotdeilppussirewopoN
ytluafsiylppusrewopCA
)PCO(tnerrucrevOB+semit2
)draoBD(.detrohssi)4086/3086Q(TUO.H
)draoBD(.detrohssi)6086Q(TEFytiraeniL
)draoBD(.detrohssiCIrewoP4066CI
noemoctonseodrewoP
detrohssahenilrewopnodaoL
deppotsnoitcelfeDlacitreVsemit4
)draoBD(nepo5386RdeilppustonsiV51+
)draoBD(nepo4386RdeilppustonsiV51-
)draoBD(detrohssi0076CI
deppotssaheslupnoitcelfedlacitreV
detrohssahenilrewoP
egasseMrorrE
DEL
sehsalF
rorreoN00
devreseR10
)noitcetorPtnerruCrevO(PCO20
)noitcetorPegatloVrevO(PVO30
noitcetorPlacitreV40
16TTelbane,s'03retfastratskcehc(BKAelbatsnU
)26TTelbasid
50
noitcetorPlatnoziroH60
noitcetorPrekaepS70
rorre0subC2I80
redoceD-txeT-eleTB-M90
MVN,23C42TSB-M01
redoceDruoloCniaM,0239ADTB-J11
xoBerutaeFB-2B/1B21
retrevnoC-A/DB-1B31
dnekcaBB-E41
rossecorPdnuoS,D0143PSMB-J51
ediWotuA,7502DXCB-J61
MARlanretxE71
To Next Page
Loading...
Need help?
General