- 7 -
WAX2
RM-ED005
WAX2 SELF DIAGNOSTIC SOFTWARE
The identification of errors within the WAX2 chassis is triggered in one of two ways :- 1: Busy or 2: Device failure to respond to IIC. In the
event of one of these situations arising the software will first try to release the bus if busy (Failure to do so will report with a continuous
flashing LED) and then communicate with each device in turn to establish if a device is faulty. If a device is found to be faulty the relevant
device number will be displayed through the LED (Series of flashes which must be counted).
Flash Timing Example : e.g. error number 3
StBy LED
ON ON
OFF
OFF
LED Error Code
DEL
RORRE
EDOC
NOITPIRCSEDRORRE
1)3TRELACD(elbuorTegatloVylppuSV33GERNU
2)2TRELACD(elbuorTegatloVV6/V5ED,8.1DV
3)1TRELACD(
elbuorTegatloVV5LENAP,V5.01GERNU
4elbuorTthgilkcaB
5elbuorTegatloVylppuSniaM
6elbuorTegatloVdeilppArekaepS
7)
edislenapehtno.pse(erutarepmeT-edisnIniesaercnInarotinoM
8elbuorTCItnedirT
9)TORP_SC_SB/snoitacinummoC(el
buorTTTD
To Next Page
Loading...
