Do you have a question about the Sony KV-21FS100 and is the answer not in the manual?
Procedure for checking AC leakage and finding a proper earth ground connection.
Explains LED flash codes for error detection and probable causes.
Instructions for bringing up, handling, clearing, and quitting the self-diagnostic screen.
Steps for removing the rear cover and the main chassis assembly.
Procedures for picture tube removal and safe handling of the anode cap.
Covers initial beam alignment and color convergence adjustments.
Details adjustments for picture focus and screen grid voltage.
Explains how to enter, set, and exit the service adjustment mode.
Process for adjusting white balance for accurate color reproduction.
Method to confirm and readjust the R565 component for HV hold-down.
Procedure to confirm and adjust B+ voltage critical for safety.
Steps for setting service mode, memory, and using remote controls.
Table for ID mapping across different models and destinations.
Adjustments for H/V frequency, SCON, and drive signals on the A Board.
Procedures for adjusting display position, sub brightness, and sub hue/color.
Covers H/V Size, Center, Linearity, Correction, Pin Amp, and Trapezoid adjustments.
Procedures for adjusting V. Angle, V. Bow, Upper/Low Pin.
Identifies locations of circuit boards and explains diagram conventions.
Provides overall system block diagram and detailed A Board schematic.
A Board transistor/IC voltages, waveforms, and locator table.
Schematic, IC, and transistor data for the CV Board.
Visuals and part numbers for common semiconductors used in the unit.
Exploded view of the chassis assembly for KV-21FM100 model.
Exploded view of the chassis assembly for KV-20FS100/21FS100 models.
Exploded view of the chassis assembly for KV-20FV300/21FV300 models.
Exploded view of the chassis assembly for KV-24FV300/25FV300 models.
List of common components used across multiple models.
Lists parts specific to different TV models (e.g., KV-21FM100(N)).
Instructions for printing full-size and tiled schematic diagrams.
Guide on how to print only a selected portion of a schematic.