7
Step 2: Setting the
time
You must set the time before using the timer
functions.
1 Press c/CLOCK SET.
The hour indication flashes.
2 Press TUNING +/– to set the hour.
3 Press ENTER/NEXT.
The minute indication flashes.
4 Press TUNING +/– to set the
minute.
5 Press ENTER/NEXT.
The clock starts.
3,51 2,4
Tip
If you make a mistake, start over from step 1.
To change the time
The previous explanation shows you how to set the
time while the power is off. To change the time
while the power is on, do the following:
1 Press c/CLOCK SET.
2 Press TUNING +/– to select SET CLOCK.
3 Press ENTER/NEXT.
4 Perform steps 2 through 5 in the previous
explanation.
Note
The clock setting is canceled when you disconnect
the power cord or if a power failure occurs.
To Next Page
Loading...
Need help?
General
