Sony LT22i - Page 72

Video resolution
Adjust the video resolution for different formats.
Photo light
Use the light to record videos when lighting conditions are poor or when there is a
backlight.
On
Off
Sometimes the video quality can be better without a light, even if lighting conditions are poor.
Self-timer
With the self-timer you can record a video without holding the device. Use it to record
group videos where everyone can be in the video. You can also use the self-timer to
avoid shaking the camera when recording videos.
On (10 sec.)
Set a 10-second delay from when you tap the camera screen until the video begins to record.
On (2 sec.)
Set a 2-second delay from when you tap the camera screen until the video begins to record.
Off
The video begins to record as soon as you tap the camera screen.
Quick launch
Quick launch settings let you activate the camera from sleep mode by pressing and
holding down the camera key.
Launch and capture
By pressing and holding down the camera key, the first photo is captured immediately after the camera
is launched from sleep mode.
Launch only
By pressing and holding down the camera key, the camera is launched from sleep mode.
Off
While the phone is in sleep mode, the camera cannot be launched, even when you press and hold
down the camera key.
Focus mode
The focus setting controls which part of a video should be sharp. When continuous
autofocus is on, the camera keeps adjusting focus so that the area within the white focus
frame stays sharp.
Single autofocus
The camera automatically focuses on the selected subject. Continuous autofocus is
on.
Face detection
The camera automatically detects up to five human faces, indicated by frames on
the screen. The camera automatically focuses on the nearest face. You can also
select which face to focus on by tapping it on the screen. When you tap the
camera screen, a green frame shows which face is selected and in focus. Face
detection cannot be used for all scene types. Continuous autofocus is on.
Exposure value
This setting allows you to determine the amount of light in the image you capture. A higher value
indicates an increased amount of light.
72
This is an Internet version of this publication. © Print only for private use.