4 If Passkey* input
is
required on the
display of the device to be connected,
input "0000."
A list
of
detected devices appears
in
the
display
of
the device
to
be
connected. This
unit
is
displayed
as
"XPLOD"
on
the device
to
be connected.
This unit and the Bluetooth device memorize
each other's information, and when pairing
is
made, the unit
is
ready for connection to the
device.
Input passkey.
"0000"
-
-
~
xxxx
..,
-
-
~
0]
To
use the Bluetooth function, the following
procedure is necessary.
Bluetooth
(Handsfree
calling
and
Music
streaming)
Bluetooth
operations
Support site
http://esupport.sony.com
http://www.xplodsony.com/
o Pairing
When connecting Bluetooth devices for the
first time, mutual registration
is
required. This
is
called "pairing." This registration (pairing)
is
required only for the first time,
as
this unit
and the other devices will recognize each
other automatically from the next time.
You
can pair
up
to 8 devices. (Depending on the
device, you may need to input a passkey for
each connection.)
e Connection
To
use the device after pairing is made, start
the connection. Sometimes pairing allows
to
connect automatically.
e Handsfree callinglMusic streaming
You
can talk handsfree and listen to music
when the connection is made.
•
22
Pairing
First, register ("pair") a Bluetooth device
(cellular phone, etc.) and this unit with each
other.
You
can pair up to 8 devices. Once pairing
is established, there is no need for pairing again.
1 Place the Bluetooth device within 1 m
(3
ft)
of
this unit.
2 Press and hold
@)
until"
0 "flashes
(about 5 seconds).
The unit enters pairing standby mode.
flashing
3 Set the Bluetooth device to search for
this unit.
"0"
flashes and then stays lit after pairing is
complete.
S Set the Bluetooth device to connect to
this unit.
"1iI~"
or
"f]~"
appears when the connection
is
made.
* Passkey
may
be called "passcode," "PIN code," "PIN
number"
or
"Password," etc., depending on the
device.
Note
Pairing standby mode
is
not
released until the
connection
is made.
About Bluetooth icons
The following icons are used by this unit.
lit:
Bluetooth signal on
0
flashing:
Pairing standby mode
off: Bluetooth signal off
lit:
Connection successful
~~
flashing:
Connecting
off:
No connection
lit:
Connection successful
~~
flashing:
Connecting
off:
No connection
To Next Page
Loading...
Need help?
General
