Canceling
the
DEMO
mode
You
can cancel the demonstration display which
appears during turning off.
1 Press and hold the select button.
The setup display appears.
2 Press the select button repeatedly
until "DEMO" appears.
3 Rotate the control dial to select
"DEMO-OFF."
4 Press and hold the select button.
The setup is complete and the display returns
to normal reception/play mode.
Preparing
the
card
remote
commander
Remove the insulation film.
Tip
For
how
to
replace the battery, see page 29.
Setting
the
clock
The clock uses a 12-hour digital indication.
1 Press and hold the select button.
The setup display appears.
2 Press the select button repeatedly
until "CLOCK-ADJ" appears.
3 Press
(SEEK)
+.
The hour indication flashes.
4 Rotate the control dial to set the hour
and minute.
To
move the digital indication, press
(SEEK)
-/+.
5 After setting the minute, press the
select button.
The setup
is
complete and the clock starts.
To
display the clock, press
(DSPL).
Press
(
DSPL)
again to return to the previous display.
Tip
You
can
set
the clock automatically with the RDS
feature (page
17).
Detaching
the
front
panel
You
can detach the front panel
of
this unit to
prevent theft.
Caution alarm
If
you turn the ignition switch to the OFF
position without detaching the front panel, the
caution alarm will sound for a few seconds.
The alarm will only sound
if
the built-in
amplifier is used.
1 Press and hold
(SOURCE/OFF
).
The unit
is
turned off.
2 Press
~,
then pUll it off towards you.
Notes
• Do not drop
or
put
excessive pressure on the front
panel
and
display window.
• Do
not
subject the front
panel
to
heat/high
temperature
or
moisture. Avoid leaving it in a parked
car
or
on a dashboard/rear
tray.
•
• Do
not
detach the front panel during playback
of
the
USB device, otherwise USB data
may
be
damaged.
Attaching the front panel
Engage part ®
of
the front panel with part ®
of
the unit,
as
illustrated, and push the left side into
position until it clicks.
Note
Do
not
put
anything on the inner surface
of
the front
panel.
7
To Next Page
Loading...
Need help?
General
