25
GB
MHC-RV7 4-240-085-11 (1)
Other Features
3 Press KARAOKE PON.
Each time you press the button, the display
changes cyclically as follows:
KARAOKE PON t MPX R t MPX L
t KARAOKE OFF
The “m” indicator appears in the display
when a karaoke mode is activated.
To sing karaoke by decreasing the vocal
level of the music source, select
“KARAOKE PON”.
To sing karaoke of multiplex CD select
“MPX R” or “MPX L”.
4 Start playing the music and adjust the
volume.
5 Adjust the microphone volume by
turning MIC LEVEL.
To
Use VIDEO CDs
Cancel karaoke mode
Adjust the microphone
echo
Adjust the key
(For VCD/audio CD
only)
Do this
Turn on your TV and select
the video input.
Turn MIC LEVEL to MIN,
disconnect the microphone
from MIC jack, then press
KARAOKE PON
repeatedly until “m”
disappears.
Turn ECHO LEVEL to
adjust the echo effect. To
cancel the echo effect, turn
ECHO LEVEL to MIN.
Press KEY CONTROL #
or 2 on the remote to suit
your vocal range. You can
adjust the key higher or
lower in 13 halftone steps
(26 ~ #6).
Notes
• With some songs, vocals may not be cancelled
when you select “KARAOKE PON”.
• During KARAOKE PON, the equalizer and cinema
space effect settings cannot be changed.
• If you press EFFECT ON/OFF or recall a sound
effect, the karaoke mode is canceled.
• The instrumental sound may be reduced as well as
the singer’s voice when the sound is recorded in
monaural.
• Karaoke can be used during CD function only.
• The singer’s voice may not be reduced when:
— only a few instruments are playing.
— a duet is being played.
— the source has strong echoes or chorus.
— the singer’s voice deviates from the center.
— the voice on the source is singing in high
soprano or tenor.
Mixing and recording
sounds
You can “mix” sounds by playing one of the
components and singing or speaking into a
microphone.
The mixed sound can be recorded on a tape.
1 Do the procedure for singing along
(steps 1 to 5 on page 24). Then, insert a
recordable tape in deck B.
2 Press the function button of the source
you want to record (e.g., CD).
If you want to record from TAPE A, press
TAPE A/B repeatedly until TAPE A is
selected.
3 Press REC PAUSE/START.
Deck B standby for recording. The REC
PAUSE/START button flashes.
4 Press DIRECTION repeatedly to select
g to record on one side. Select j
(or RELAY) to record on both sides.
5 Press REC PAUSE/START.
Recording starts.
continued
To Next Page
Loading...
Need help?
General
