153
The button color varies as follows, according to the
register state.
Gray characters on black: Register not containing a
saved snapshot
White icon/characters on dark blue: Register containing
a saved snapshot
Lit orange: Last recalled register
When both the main pattern and sub pattern are selected
for a pattern mix, the main pattern image is displayed.
Selecting a wipe pattern
1
In the M/E-1 bank Flexi Pad control block, press the
[WIPE] button.
This switches the memory recall section to wipe
snapshot operation mode.
2
Press the [PTN NO.] button in the memory recall
section.
3
Use the numeric keypad to enter the pattern number
consisting of up to three digits, and press the [ENTER]
button.
The entry is applied, and the memory recall section
switches back to wipe snapshot operation mode. The
selected wipe pattern number is displayed on the top
right button in the memory recall section.
Saving a wipe snapshot
1
Configure the wipe you want to save.
2
In the Flexi Pad control block, press and hold the
[KEY] button, and press the button for the register you
want to save.
The selected button is lit orange, and the set wipe
pattern image is displayed. The set wipe pattern
number is displayed on the top right button in the
memory recall section.
If you press a button in which a wipe snapshot is
already saved, the existing contents of the register will
be overwritten.
Recalling a wipe snapshot
1
In the Flexi Pad control block, press the [WIPE]
button.
This switches the memory recall section to wipe
snapshot operation mode.
2
Press the register button for register with the wipe
snapshot you want to recall.
The selected button is lit orange, and the wipe
snapshot is recalled.
The set wipe pattern number is displayed on the top
right button in the memory recall section.
To cancel a wipe snapshot recall operation
To cancel the wipe snapshot recall, press the [UNDO]
button.
Deleting a wipe snapshot
1
In the Flexi Pad control block, press the [WIPE]
button.
This switches the memory recall section to wipe
snapshot operation mode.
2
Press and hold the [DEL] button, and press the button
of the register in which the wipe snapshot you want to
delete is saved.
The selected button changes to register number
display.
Wipe Snapshot Operations (Menu)
Use the Wipe >Wipe Snapshot menu in each switcher
bank.
This section describes operations on the M/E-1 bank
(M/E-1 >Wipe >Wipe Snapshot menu) as an example.
Button displays
You press buttons in the memory recall section to select
registers (1 to 10).
Note
Note
Memory recall buttons
To Next Page
Loading...
