164
4
In the <Crop Mode> group, press [Remove From
Begin].
The Remove From Begin menu (1165.1) appears.
5
In the <Crop Transition> group, select the execution
mode for the DME wipe crop transition.
Cut: Cut mode. The cropping does not change during
the transition, but at the end point of the transition
the cropping is removed (enlarges).
Last 5%: The cropping is maintained for the first 95%
of the transition, and is progressively removed
during the last 5% of the transition (enlarges).
Linear: The cropping is removed linearly from the
start of the transition through the whole course of
the transition (enlarges).
To set the timing of transition completion
When the execution mode for a DME wipe crop transition
is set to [Last 5%], you can select the timing of transition
completion from 70% ([Last 30%]), 95% ([Last 5%]), and
100% ([Off]).
1
Open the M/E-1 >DME Wipe >Modify menu (1165).
2
In the <Crop Mode> group, press [Remove From
Begin].
The Remove From Begin menu (1165.1) appears.
3
In the <Release Transition> group, select the timing of
transition completion.
Last 30%: The transition completes at the end of 70%
of the transition execution time. The transition has
a dead band from 70% to 95% of the transition
time.
Last 5%: The transition completes at the end of 95%
of the transition execution time. When the
transition completes, the cropping is removed
during the last 5% (enlarges).
Off: The transition completes at the end of the
transition execution time. During the last 5% of
the transition, the transition and cropping removal
proceed together.
DME Wipe Modify Clear
Press [Default Recall] at the lower left of the menu display,
turning it on, then press the VF6 button ([DME Wipe]) to
return the DME wipe settings to their initial status.
For details about initial status, see “Power-On (Startup)
State Selection” (page 398).
t: Transition execution
time
y: Change in transition
and cropping amount
Transition
Crop
t: Transition execution time
y: Change in transition and
cropping amount
Dead band
Transition
Crop
To Next Page
Loading...
