154
The wipe pattern image and pattern number are displayed
on buttons for registers with a registered snapshot. You can
also set to display the register name instead of the pattern
number in the Setup menu (see page 431).
• The menu settings of the memory recall buttons are
linked to the Flexi Pad control block.
• When both the main pattern and sub pattern are selected
for a pattern mix, the main pattern image and number are
displayed.
Selecting a wipe pattern
1
In the M/E-1 >Wipe >Wipe Snapshot menu (1157),
press the [Pattern No] memory recall button.
2
Use the numeric keypad window to enter the pattern
number consisting of up to three digits, and press [Enter].
The entry is applied, and the selected wipe pattern
image and pattern number are displayed in the
“Current Pattern No” field on the top left.
Saving a wipe snapshot
1
Configure the wipe you want to save.
2
In the M/E-1 >Wipe >Wipe Snapshot menu (1157),
press [Store], turning it on.
3
Press the memory recall button for the register you
want to save.
The selected button is lit orange, and the set wipe
pattern image and number are displayed.
If you press a button in which a wipe snapshot is
already saved, the existing contents of the register will
be overwritten.
Recalling a wipe snapshot
In the M/E-1 >Wipe >Wipe Snapshot menu (1157), press
the memory recall button for the register with the wipe
snapshot you want to recall.
The selected button is lit orange, and the wipe snapshot is
recalled.
Deleting a wipe snapshot
1
In the M/E-1 >Wipe >Wipe Snapshot menu (1157),
press [Delete], turning it on.
2
Press the memory recall button for the register with the
wipe snapshot you want to delete.
Notes
Note
To Next Page
Loading...
