5
motor, DC
(spindle) (M601)
4
three screws
(M1.4)
1
Remove six solders of
motor flexible board.
qa
motor, DC (over write head up/down)
(M603)
6
two screws (M1.4)
qs
chassis assy, gear
9
screw (M1.2)
0
gear (HA)
gear (HA)
chassis assy, gear
2.65 mm
motor, DC (over write head
up/down) (M603)
8
gear (HB)
7
washer (0.8-2.5)
2
washer (0.8-2.5)
3
gear (HC)
Note: Press-fit the gear (HA) up to the
position of the “motor, DC (over
write head up/down) (M603) as shown
below.
3-9. “MOTOR, DC (SPINDLE) (M601)”, “MOTOR, DC (OVER WRITE HEAD UP/DOWN) (M603)”
To Next Page
Loading...
