6
NW-E103/E105/E107
SECTION 3
TEST MODE
STANDING PROCEDURE
Procedure 1: In HOLD state, while pushing Nx button, set a
dry battery.
When the test mode is set, the LCD display appears
as shown below.
Procedure 2: After starting up test mode, the following contents
can be checked. (Before key input, select the
from HOLD state with S706.)
TEST MODE
• Nx button
The KEY test mode is activated. All key inputs are completed,
then Nx button is pressed, restart. (Be aware that the
initialization is included on all key input.)
• [MENU] button
EL0: ON/OFF EL back lights on/off.
• + > button
Ports: ON EL back lights on.
• . – button
Ports: OFF EL back lights off.
• + > button ( state with S706)
All LCD lights on.
• . – button ( state with S706)
All LCD lights off.
• [VOLUME +] button
BEEP turns on.
• [VOLUME --] button
BEEP turns off.
• [ REPEAT SOUND] button
Initialized. (Turns to the factory preset state, time, volume setting
and so on.)
The music data, files and so on in the memory are not changed.
•
512M 1.00.00 J11
To Next Page
Loading...
