Sony PCM-800 - Page 86

craters lll
5-10 Setting a Park Position
PS
RRA
a
Ia
aN
a
EEN
a
Ne
SRE
cl
SRE
ogee
Oe
OE
ELE
Cae
Oe
REN
ge
ee
Te
5-40
Manual position
Chapter 5 Operation
Automatic
accommodation
of
the
park
position
10
Hold
down
either
the
up
(A)
or
the
down
(¥)
key
and
press
the
other.
“At.
P.
PoSi”
(At
Park
Position)
will
appear
in
the
display
window
and
a
new
park
position
will
be
set
up
for
the
lag
shown
to
be
compensated for.
When
the
setup
is
complete
and
the
park
position
setting
mode
is
disabled
as
a
result,
the
“At.
P.
PoSi”
display
disappears
and
the
slave
PCM-800
goes
into
chase
mode
and
is
quick
to
lock
to
the
master.
With the RM-D800
1
Marking sure that your VTR (machine 9) is under control, press
CHASE to locate the PCM-800 to the same time code address as
the VTR.
When the relative difference between the master and slave time
code numbers becomes 00:00, as shown on the screen, start the
VTR.
Press ESCAPE.
The lag in the play time on the PCM-800 will be entered into the
Park Position screen, and the Test mode will switch “Off,”
automaticaly.
ESCAPE has no effect if pressed when the slave is more than 2
seconds behind the master.
The park position of the slave can also manually be set up or trimmed
as follows:
1
2
Press DISPLAY as many times as necessary to activate the frame
accurate DIFF mode.
Hold down the down (¥) key and press DISPLAY to activate the
park position setting mode. “P.PoS 010” will appear in the display
window, showing that the slave will park 10 frames ahead of the
otherwise “will be” point. To change this default setting, perform
the following steps.
Each time you press the up (A) or the down (W) key the display
will increment/decrement in 1 frame steps. You cannot enter 2
seconds or more. The minimum setting is 0 second.
When the desired numbers are displayed, press DISPLAY to
switch the display back to its DIFF mode.