How to fix Sony PL-ES3 when the power is not turned on?
If the Sony Projector's power is not turning on, wait about 90 seconds before attempting to turn it on again, especially if it was recently turned off. Make sure that the lamp cover and the air filter cover are securely closed and attached.
What to do if Sony PL-ES3 flashes red 6 times?
If the '/1' indicator flashes red six times on your Sony Projector, unplug the AC power cord from the wall outlet after the '/1' indicator goes out. Then, plug the power cord back into the wall outlet and turn the projector on again. If the '/1' flashes in red and the problem persists, the electrical system has failed.
What to do if my Sony Projector has no picture?
If your Sony Projector shows no picture, ensure all cable connections are correct and securely connected. Verify that the input selection on the projector matches the source you're using. If the picture is muted, press the 'PIC MUTING' key to unmute it. Also, if you're using a computer, make sure its signal is set to output only to an external monitor.
How to fix a noisy picture on a Sony Projector?
To resolve a noisy picture on your Sony Projector, try changing the desktop pattern on the connected computer. The noise may appear depending on the combination of the number of dots input from the computer and the number of pixels on the LCD panel.
What to do if Sony Projector picture is not clear?
If your Sony Projector's picture is not clear, start by adjusting the focus. If that doesn't work, condensation may have accumulated on the lens. Leave the projector on for about two hours to allow the condensation to clear.
How to stop Sony PL-ES3 picture from flickering?
If the picture on your Sony Projector flickers, adjust the 'Dot Phase' in the Input setting menu.
To Next Page
General
