Sony PS-4300 - Notes on Installation; Turntable Assembly

NOTES ON INSTALLATION
e@Place the turntable on a level surface.
@Allow 10cm (4 inches) clearance behind the unit so that the
cover can be opened.
— 430mm
{167ginches)
425mm
{16 Yinches)
@The turntable has integral bases supported by resilient feet
that isolate the mechanism from external shock and vibration.
Float the turntable horizontally by turning the feet counter-
clockwise.
However, if placing the turntable on a soft surface, turn the
feet clockwise and lock them, although the cushioning effect
will be eliminated in the locked position.
These feet are also adjustable in height for leveling the turn-
table. For placing it on an uneven surface, turn each foot
counterclockwise until the unit is level.
resilient foot
@Avoid placing the unit near electrical appliances (such as a
television, hair dryer, or fluorescentiamp) which may cause
hum or noise.
e@Avoid any vibration (such as from speakers, slamming of
doors, etc.).
@ Keep the unit away from direct sunlight, extremes of tempera-
ture, or excessive dust and moisture.
TURNTABLE ASSEMBLY
Do not connect the power cord or the connecting cords until
after finishing the assembly.
Remove all packing material and clean the cabinet.
Check that the resilient feet are released.
@ Remove the two red-painted transit screws. Store them in
the holes on the caution label. (These screws will be required
at the time of repacking. See the “Repacking instructions” on
page 13.
@ Carefully place the platter on the motor board by matching
the center hole and the center spindle.
@Do not touch the magnetic coating with your fingers or tools
to avoid scratching it and damaging the electronic speed control
system.
@ Place the Rubber Mat on the Platter.
e@ Never connect the power cord without the Platter installed.
Otherwise the motor will run at an uncontrolled speed.
e@Be careful that no foreign objects lodge under the Platter.
@Do not attempt to rotate the Platter counterclockwise by hand,
@Save the packing box and materials for possible future use.
To remove the dust cover
Open the dust cover and slide it backwards by holding with
both hands.