Need help?Do you have a question about the Sony PS-LX49 and is the answer not in the manual?
General| Drive System | Belt drive |
|---|---|
| Motor | DC motor |
| Output Voltage | 2.5mV |
| Power Requirements | AC 120V, 60Hz |
| Speed | 33 1/3, 45 rpm |
| Cartridge | Moving magnet |
| Wow and Flutter | 0.25% (WRMS) |
| Recommended Load Impedance | 47k ohms |
| Platter | Aluminum Die-Cast |
| Output Level | 2.5 mV |
| Frequency Response | 20Hz to 20kHz |
| Tonearm Type | Static Balance Straight Tonearm |
Record model and serial numbers for future reference and dealer inquiries.
Safety guidelines for operating the unit, including voltage, liquid exposure, and unplugging.
Recommendations for unit placement regarding heat, sunlight, and air circulation.
Instructions for cleaning the unit's cabinet and dust cover without damaging the finish.
Instructions on how to open and remove the turntable's dust cover.
Guide to cleaning the stylus using a soft brush or approved fluid.
Procedure for cleaning the unit's exterior surfaces without damaging the finish.
Information on when and how to replace the stylus for optimal performance.
To Next Page
