Sony PS-X600 - Operating Voltage; Precautions; On safety; On installation

OPERATING VOLTAGE
Before connecting the unit to the power source, check that the
operating voltage of your unit is the same as the local power line
voltage.
The model for European countries (Type 1) operates on 220 V ac.
The model for the United Kingdom (Type 2) operates on 240 V ac.
The model for other countries (Type 3) operates on either 110-120 or
220-240 V ac. The voltage selector is located on the rear panel. If
the selector must be reset, disconnect the ac power cord and slide
the selector to the desired voltage.
For the Customers in the United Kingdom
important
The wires in the mains lead are coloured in accordance with the
following code:
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this apparatus may
not correspond with the coloured markings identifying the ter-
minals in your plug proceed as follows:
The wire which is coloured blue must be connected to the terminal
which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the ter-
minal which is marked with the letter L or coloured red.
PRECAUTIONS
On safety
@ Before operating the unit, be sure that the operating voltage of
your unit is identical with that of your local power supply.
@ Should any solid object or liquid fall into the cabinet, unplug the
unit and have it checked by qualified personnel before operating it
any further.
@ Unplug the unit from the wall outlet if it is not to be used for an
extended period of time. To disconnect the cord, pull it out by the
plug. Never pull the cord itself.
On instailation
@ Piace the turntable on a level surface.
@ Avoid placing the unit near electrical appliances (Such as a televi-
_ sion, hair dryer, or fluorescent lamp) which may cause hum or
noise.
@ Place the turntable where it will not be subject to any vibration,
such as from speakers, slamming of doors, etc.
@Keep the unit away from direct sunlight, extremes of
temperature, and excessive dust and moisture.
@ Allow at least 10 cm (4 inches) clearance behind the unit so that
the cover can be opened.
380 mm
(approx. 15 in)
(approx. 165/s in)
@ The turntable has resilient feet that isolate the mechanism from
external shock and vibration. If the unit has not been placed ona
level surface, turn the feet to level the unit.
ny
On repacking
Do not throw away the carton and packing materials. It is an ideal
container in which to transport the unit. When shipping the unit to
another location, repack it as illustrated on the carton box observ-
ing the following points.
@ Secure the tonearm to the arm rest.
@ Fix the transit screws in the original positions.