Sony PVM-L2300 - Functions Supported in Software Version 1.1 and 1.2

9
Functions Supported in Software Version 1.1 and 1.2
Chapter 1 Overview
Functions Supported in Software Version 1.1 and 1.2
The following new functions are supported for Version 1.1 and Version 1.2 of the PVM-L2300.
Software Version 1.1
Software Version 1.2
Menu Supported function Reference page
• 3G/HD/SD-SDI Auto
•3G-SDI
(in the 3G/HD/SD-SDI menu of the Format menu of
the Input Configuration menu)
The BKM-250TG (optional) is available.
3G-SDI, HD-SDI, Dual Link HD-SDI and SD-SDI signals
can be input by installing the BKM-250TG.
50
Color Gamut
(in the Input Configuration menu)
The color gamut to be used (color space and gamma) is
set for each channel.
54
Marker Preset
(in the Input Configuration menu)
The marker preset data are set for each channel. 54
Aspect Correction
(in the Native Scan Mode menu of the Display
Setting menu)
When the input signal system is the SD signal of
720 × 576 or 1440 × 576 and Native Scan Mode is set to
Aspect Correction and the aspect ratio is 16:9, no
display area of the left and right sides over the H size
(1920) is displayed by sliding the picture with the
PHASE knob of the controller.
57, 83
Audio Level Meter
(in the Function Switch menu of the Display
Function menu)
(in the On Screen Set menu of the System
Configuration menu)
The audio level of the embedded audio signals
superimposed on the SDI signals is displayed by
installing the BKM-250TG (optional).
64, 70, 89
ALM Hold Reset
(in the Function Switch menu of the Display
Function menu)
65
Time Code
(in the Function Switch menu of the Display
Function menu)
(in the On Screen Set menu of the System
Configuration menu)
The time code superimposed on the SDI signals is
displayed by installing the BKM-250TG (optional).
65, 70, 90
•Auto 1
•Auto 2
(in the Type menu of the Closed Caption menu of
the On Screen Set menu of the System
Configuration menu)
Auto 1 and Auto 2 can be selected for the closed
caption type (when the BKM-244CC (optional) is
installed).
70
SDI Payload ID Status
(in the Status menu)
The information on the Payload ID data superimposed
on the SDI signal input from the BKM-250TG (optional)
and current signal status of the monitor are displayed.
76
Menu Supported function Reference page
• Checkerboard
•L/R Switch
(in the Function Switch menu of the Display
Function menu)
(in the Parallel Remote menu of the System
Configuration menu)
(in the Function Key menu of the Controller menu)
Simultaneous display or left/right switching display of
the left and right 3D video signals is available by
installing an optional BKM-250TG (with serial number
7100001 or higher).
65, 68, 80, 91