How to fix Sony DVR when recording cannot be performed?
If your Sony DVR is unable to record, check the [Setup] tab in the System screen of the web menu. If [Rec Inhi] is set to 'On', change the setting to 'Off'.
What to do if my Sony PWS-4400 unit ceases to operate correctly?
If your Sony DVR unit stops working correctly due to a malfunction or internal system error, first address the cause of the error as indicated in the error message. Then, turn the unit back on.
Why does my Sony PWS-4400 recording end abnormally?
If your Sony DVR recording ends unexpectedly, it might be because the main power switch on the connector panel was turned off, or the power cord was disconnected during recording. To prevent this, when you want to stop recording, use the On/Standby switch on the front panel to properly end the unit's operation. Also, the unit has a salvage function that helps restore data in memory with minimal loss.
What to do if files cannot be restored using salvage on Sony PWS-4400 DVR?
If you cannot restore files on your Sony DVR using the salvage function, formatting the memory should allow you to use it again.
Details the PWS-4400's capabilities, including video/audio, codecs, resolution, HFR, and ports.
Describes the buttons, indicators, and switches on the front panel of the unit.
Details the various input, output, and control connectors on the rear panel of the unit.
Explains how to connect the unit to external devices for recording or playback.
Illustrates connecting devices to use the unit as a player for playback.
Details how to configure system frequency and board settings using the web menu setup wizard.
Allows basic settings for the unit, covering board, setup, remote, network, bank, and power configurations.
Covers common issues like salvaging memory, error messages, and warning messages for problem resolution.
To Next Page
General
