RCD-W1 (US) 4-233-692-12(2)Actual page number:
22
Erasing a single track of
CD-RW disc
You can erase one track on a CD-RW at a
time. This process starts with the last track on
the disc. Please note that before erasing a track,
you must unfinalize the disc. If the disc is not
unfinalized, follow the instructions of
“Unfinalizing a CD-RW disc” (page 21).
When using the remote, set SELECT to CDR
for operations on DECK B.
1 Press the ERASE button.
The “LAST TR ERASE” indicator will
begin to flash, and the PLAY, PAUSE, and
REC indicators light up for about 8
seconds. Erasing enters in standby mode.
2 Press H while “LAST TR ERASE” is
flashing.
The last track erasing starts. During the last
track erasing, “LAST ERASE” appears in
the display and the remaining time for
erasing the last track appears in the display.
When this process is finished, the total track
number and the total playing time appears
in the display.
Notes
• The TOC (red) indicator appears on the front panel
display if the disc you put in the DECK B has not
been finalized. Check the indicator each time before
erasing the last track of a disc.
• Once erasing process starts, you cannot stop in the
middle of the process.
• Do not turn off the recorder or disconnect the
recorder from the power source in the middle of the
erasing process.
ERASE
ERASE
06REC_RCD-W1.p65 01.2.26, 1:44 PM22
To Next Page
Loading...
Need help?
General
