52
Notes on learning the signals
of an air-conditioner
About seasonal adjustments
If you change the settings of the air-
conditioner for the season, you have to
program the remote control signals of the
new settings on the Commander.
If the power-on/off operation
does not work correctly
The air-conditioner may not be turned on
or off properly with the button or key of
this Commander, for which you have
programmed its power-on/off signal.
If the Commander can operate only
“ON” with one button or key and “OFF”
with another, while your air-
conditioner’s remote control can operate
“ON/OFF” with a single button or key,
program the signal on two buttons or
keys of the Commander as follows.
1 Clear the learned power-on/off signal.
(In the example on page 51, clear the
learned signal from the SYSTEM
CONTROL 2 button.)
2 Program the signal (transmitted from
the power-on/off button of the air-
conditioner’s remote control) for the
SYSTEM CONTROL 2 button again.
3 Program the signal from the same
button of the remote control for
another button or key (for example,
the SYSTEM CONTROL 3 button).
The two buttons or keys of the
Commander have been programmed
with the power-on signal and the power-
off signal of the air-conditioner,
respectively so that you can operate the
air-conditioner with the Commander.
Transferring Data
between Commanders
You can transfer data, such as learned
signals and component code settings,
between this Commander and another
Sony RM-AV3000.
Transferring data
You can transfer all the data of this
Commander or the data of a Component
Select button or a Label key on this
Commander to another Sony RM-AV3000.
To transfer all the data of the
Commander
MENU EXIT
COMMANDER
OFF
MORE321
TV STB VCR DVD CD AMP
OTHER
TIMER LIGHT
MUTING RECALL
CHANNELVOLUME
SYSTEM CONTROL
OK
6
2
10
9
5
3
4,7
Programming a Frequently Used
Key Operation for SYSTEM
CONTROL Buttons or Label Keys
(continued)
To Next Page
