Sony RM-E700 - Page 21

While > is flashing, keep
pressing the > button of the
remote control unit of the
recorder. When >> lights up,
release the > button.
The RM-E700 has learned the
playback function. Then >> (fast-
forward) flashes.
(End
Ll _-=
SO goo | 000
0 FC |EaeSS0cnr oc
about 3~5cm
(146 ~2 inches)
_ Remote control
~- unit of the recorder
Repeat step 3 or 4 to store the functions of other buttons.
The indicator flashes in the order of:
b> (fast-forward) > <KI (rewind) > STOP — REC (recording) — 01> (frame advance playback)
— D> (slow speed playback) —> x2 (double speed playback)
When the RM-E700 has learned all the functions, the learning mode is cancelled after 3 seconds.
Check that the recorder operates correctly by pressing the buttons of the RECORDER section.
If the recorder does not operate correctly, try again from step 2.
e To turn off the power of the RM-E700, first turn the
POWER switch off, then disconnect the AC power
adaptor from the RM-E700. If you do this in the reverse
order, the stored data will be erased, and the lithium
battery will be consumed quickly.
e The RM-E700 cannot store the functions of some remote
control units such as those using supersonic waves.
Press the button within 30 seconds while the indication is
flashing. Otherwise the indications disappear and learning
mode is canceled. In this case, try again from step 2.
You can store any esired function for the flashing button.
Press the desired button.
Repeat pressing the COMMAND MEMORY button until the
x2 indication flashes. Press the COMMAND MEMORY
button again.
Press the AC button while the IWISIM@)sN@ indication is on.
Repeat pressing the COMMAND MEMORY button until the
indication to be changed appears. Press the button d the
function to be stored instead. The previous function is
erased.
e Press the button firmly for more than 3 seconds uniil the
indication changes from flashing to lighting steadily, Then
wait for 1 second after the next indication starts flashing,
and store the next function.
¢ Do not press another button until the indication stops
flashing.
e
During
the
learning
operation,
you
cannot
control
tie
player
and
recorder
with
the
RM-E700.
e When the power is turned off during the learning
operation, the stored data will be erased.
e During the learning operation, do not move the RME~700
and the remote control unit.
19