Sony RM-E700 - Page 23

You can program up to 20 Cuts for one program editing. If
you use a video equipment with the RC time code recording
function such as a CCD-V800/V800E/V801 for the player
and edit by the RC time code, you can program up to 99
Cuts.
oe aed ple
The following indications appear in the display widow of the
PLAYER section.
Direction z
Playback ~~ :
Frame-by-frame
Double speed
When you use the video equipment with the RC time code
recording function for the player, observe the following:—
e To perform editing using the RC time code, rewriting the
time code from the beginning to the end of the tape is
recommended. Otherwise accurate editing by designating
the IN point and OUT point by frame is not possible.
¢ The RC time code is not compatible with the time code of
products for institutional use or that of other
manufacturers. When editing the tape with a time code
other than the RC time code, rewrite the RC time code in
the tape first.
Note on operation
During the editing operation, wait for about 1 second
between operating each button. This could help to avoid
errors.
Preparation before Program
=ontatel
To perform the program editing, prepare the player and the
recorder as follows.
ayer
e Insert the original tape.
e When the player has an input/output selector for the
audio/video jack, set it to output.
e When the player has an edit switch, set it to on. It
prevents the picture from deteriorating.
e Set the power switch to VTR (PLAYER).
e When the player has a remote control unit, set so that the
player is not operated by the remote control unit.
e When the player has an M/S selector, set to S.
e Insert a tape which is ready to be recorded. (Check the
position of the safety tab to prevent recording.)
e Set the input selector to LINE IN.
e Make the necessary settings for recording mode,
recording level, etc. (For details, refer to the instruction
manual of the recorder.)
e When the recoder has an M/S selector, set to S.
21
|
|
|
|