Sony RM-E700 - Page 24

Program Editing—To Edit Scenes in Succession
The following indications appear during programming and
previewing. The error messages appear when the
programming was not performed correctly (page 52).
During programming, lit until the IN point is designated.
During previewing, lit while the tape moves to the IN
point of the next Cut.
awn
Li tba Ld
During programming, lit until the OUT
point is designated. Hour Minute
During previewing, lit while the tape
moves from the IN point
mM
Li
rm
LIs
Second
Cut No.
Flashing during
programming
Hi Hi Frame*
Lit during previewing
to the OUT point. the a becomes the 4-digit counter.
e For
* Appears only when the player is a video equipment with the
, see page 48.
RC time code recording function.
feyveclieame Set to Programming Mode.
unit.
The current counter of the player
appears.
1 Turn on the power on this
Press the PGM button.
The IN point of the previously
designated Cut 1 (when no
designation, ---—-) appears for
about 3 seconds, then the current
counter of the player appears. In
the display window, PGM flashes,
CUT IN and 01 light. The RM-E700
now accepts the designation of the
Cut 1 IN point.
22
feflashing
lit’ Current count © |
of the player: =
e When the counter of the vieo equipment is a 4-digit counter,
ibe