Sony RM-E700 - Page 27

e The program editing is not possible when the maximum
recording pause mode period of the recorder is shorter
than the transporting time from a Cut to the next Cut of the
original tape in the player.
e After programming, do not take the original tape out of the
player until the program editing is performed.
Press the PGM EDIT button.
Or, press the STOP button of either the PLAYER or
RECORDER section.
For some types of recorders, you must press the record
button in the playback pause mode to enter the recording
pause mode.
Press the COUNTER RESET button.
When you edit by the RC time cord, the COUNTER RESET
button does not operate.
When the counter of the player shows the hour/minute/
second indication, you can check the total program time
together with the designated cut numbers until the last
programmed Cut.
Press the LAP button.
In the display window, 01 and the time of Cut 1 appear, then
the Cut numbers from 2 and the total program time until the
displayed Cut number appear every 1 second in sequence.
Meanwhile, the TOTAL LAP indication appears. After the
time of all the designated Cuts is shown, the Cut number
indication disappears and the total program time remains.
To turn off the total program time, press the LAP button
again. The RM-E700 returns to the programming mode.
COUNTER RESET button LAP button
es |SSee
ESIone|/ oc
g p Gg, player s arts
to playback from about 15 seconds (about 15 counts for the
4-digit counter) before the IN point. The player stops at
about 2 seconds (about 2 counts for the 4-digit counter)
after the OUT point.
Using the MOVE MODE selector at the rear, you can
select tape transport mode between the Cuts. Set the
MOVE MODE selector before the program editing or
previewing.
e To fast-forward or rewind the tape, set to FF/REW.
When the interval between the Cuts is within about 1
second, the player performs normal playback or fast-
forward/reverse playback.
e To playback while fast-forwarding or reversing, set to
CUE/REV (review).
When the interval between the Cuts is within about 15
seconds, the player performs normal playback.
Using the END MODE selector, you can select either the
stop mode or pause mode for the player and recorder to be
set to after program editing, and for the player to be set to
after previewing. Set the END MODE selector before
program editing or previewing.
To set to stop mode -— Set the END MODE selector to
STOP.
To set to pause mode — Set the END MODE selector to
PAUSE.
Stop mode is recommended when you may leave the site
during program editing or previewing.
Pause mode is recommended when:
@ you continue program editing.
e you find out a Cut to be changed during previewing.
STOP
END MODE
athegaccr Ee.
20 |