SERVICE MANUAL
Sony Corporation
Home Audio Division
Published by Sony Techno Create Corporation
US Model
Canadian Model
9-887-229-01
2006D04-1
© 2006.04
Ver. 1.0 2006.04
SPECIFICATIONS
SA-FT1H/WPFT1/
SS-CNPFT1/MSPFT1/SRPFT1
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC DISTORTION:
With 6 ohm loads, from 45 – 180 Hz; rated 120 watts per
channel minimum RMS power, with no more than 10% total
harmonic distortion from 250 milliwatts to rated output.
SS-MSPFT1 (front speakers)
Speaker system 2 way, magnetically
shielded
Speaker units Woofer: 8 cm, cone type
Tweeter: 2.5 cm, balanced
dome type
Enclosure type Bass reflex
Rated impedance 8 ohms
Power handling capacity
Maximum input power: 110 W
Sensitivity level 84 dB (1 W, 1 m)
Frequency range 140 Hz - 50,000 Hz
Dimensions (w/h/d) Approx. 108 × 215 × 44 mm
with table top stand Approx. 108 × 224 × 44 mm
(Diameter of base:
150 mm)
Mass Approx. 0.5 kg
with table top stand Approx. 0.6 kg
SS-SRPFT1 (surround speakers)
Speaker system 1 way, magnetically
shielded
Speaker units Full range: 8 cm, cone type
Enclosure type Bass reflex
Rated impedance 8 ohms
Power handling capacity
Maximum input power: 110 W
Sensitivity level 84 dB (1 W, 1 m)
Frequency range 140 Hz - 20,000 Hz
Dimensions (w/h/d) Approx. 108 × 215 × 44 mm
with table top stand Approx. 108 × 224 × 44 mm
(Diameter of base:
153 mm)
Mass Approx. 0.45 kg
with table top stand Approx. 0.55 kg
• SA-FT1H is composed of following models.
COMPONENT MODEL NAME
FRONT/SURROUND SPEAKER SS-MSPFT1/SRPFT1
CENTER SPEAKER SS-CNPFT1
SUBWOOFER SA-WPFT1
– Continued on next page –
SA-WPFT1 SS-MSPFT1
SS-SRPFT1
SS-CNPFT1
HOME THEATRE SPEAKER SYSTEM
To Next Page
Need help?
General
