Sony SA-WMSP87 - Diagrams Overview; Printed Wiring Board Notes; Schematic Diagram Notes; Circuit Boards Location

33
SA-WMSP87/WMSP87E
SA-WMSP87/WMSP87E
Note on Printed Wiring Boards:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
• : Pattern from the side which enables seeing.
Note on Schematic Diagrams:
• All capacitors are in µF unless otherwise noted. (p: pF) 50
WV or less are not indicated except for electrolytics and
tantalums.
• 2 : nonflammable resistor.
• 5 : fusible resistor.
• All resistors are in Ω and
1
/
4
W or less unless otherwise
specified.
• C : panel designation.
• A : B+ Line.
• B : B– Line.
•Voltages and dc with respect to ground under no-signal
conditions.
no mark : Power on
•Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal production
tolerances.
• Signal path.
F : AUDIO
•Abbreviation
CND : Canadian model
E51 : Chilean and Peruvian model
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
Note:
The components identi-
fied by mark 0 or dot-
ted line with mark 0 are
critical for safety.
Replace only with part
number specified.
Note:
Les composants identifiés
par une marque 0 sont cri-
tiques pour la sécurité.
Ne les remplacer que par une
piéce portant le numéro
spécifié.
• Circuit Boards Location
CONTROL board (WMSP87)
INPUT board
MAIN board
POWER TRANS board
SWITCH board (WMSP87)
CONTROL board
(WMSP87E)
SWITCH board
(WMSP87E)
LED board
(WMSP87E)
(WMSP87E) (WMSP87)
SECTION 1
DIAGRAMS
MEMO