PLEASE READ ME FIRST FOR SETUP INSTRUCTIONS
For Optimal Performance the video settings should be configured to 1280 × 1024 resolution at 60 Hz for
Windows
®
95, 98, NT, Me, 2000, XP.
Windows is a registered trademark of the Microsoft
®
Corporation.
Step 1:
Connect your display to your computer and then turn on the
computer. Turn on your Display power switch located on the bottom
left side of the panel (Fig. 1), then press the power button on the front
panel until the green light is on (Fig. 2). If no image appears, press
the “INPUT” selector button slowly and toggle through the 3 inputs
positions:
INPUT1: DVI-D
mM
INPUT1: HD15
mM
INPUT2: HD15
until the desired input is selected.
This monitor complies with the “DDC” Plug & Play standard and
should be recognized by the computer.
Fig. 1 Fig. 2
Note
If the computer does not recognize the monitor, install the information file for this monitor
using the supplied Windows Monitor Information/Windows Utility/Macintosh Utility Disk.
For details on installing, refer to the ReadMe E (English version) file on the disk.
Sony Corporation © 2002 Printed in Thailand
4-088-537-31(1)
(Continued)
MAIN POWER
Lights in red
Lights in green
X/P series
To Next Page
Need help?
General
