What to do if NO INPUT SIGNAL appears on Sony Monitor?
If you see 'NO INPUT SIGNAL' on your Sony Monitor, it means the monitor isn't receiving a signal from the connected device. Here's what to check: * Ensure the video signal cable is securely connected and all plugs are firmly seated. * Inspect the video input connector for bent or pushed-in pins. * Verify that the input select setting is correct.
How to fix 'CABLE DISCONNECTED' on Sony Monitor?
If your Sony Monitor displays 'CABLE DISCONNECTED', it means the video signal cable isn't properly connected. To resolve this: * Make sure the video signal cable is properly connected and all plugs are firmly seated in their sockets. * Check the video input connector’s pins are not bent or pushed in. * Ensure that the input select setting is correct. Also, if you are using a non-supplied video signal cable, this message may appear before the monitor enters power saving mode, which is normal.
Why does my Sony SDM-P82 Monitor say 'OUT OF SCAN RANGE'?
The 'OUT OF SCAN RANGE' message on your Sony Monitor indicates that the input signal from your computer isn't supported by the monitor's specifications. To fix this, check that the video frequency range is within the specified limits for the monitor. If you recently replaced an older monitor, reconnect the old one and adjust the computer's graphics board settings to these ranges: Horizontal frequency: 28 – 92 kHz, Vertical frequency: 56 – 85 Hz, Resolution: 1280 × 1024 or less.
How to stop my Sony SDM-P82 Monitor from turning off automatically?
If your Sony Monitor turns off after a period of time, disable the power saving function. Set the power saving function to OFF.
What to do if my Sony SDM-P82 says 'CABLE DISCONNECTED'?
If the message 'CABLE DISCONNECTED' appears on your Sony Monitor, ensure the video signal cable is correctly connected and all plugs are firmly seated in their sockets. Also, inspect the video input connector for bent or pushed-in pins. Verify that the input select setting is correct. Note that using a non-supplied video signal cable may cause this message to appear before the power saving mode activates; this is not a malfunction.
Instructions for connecting the monitor to a computer via DVI-D.
Instructions for connecting the monitor to a computer via HD15 analog.
Steps to connect the monitor to a power source.
Instructions for managing cables and turning on the monitor and computer.
Explains common on-screen messages and their causes.
To Next Page
General
