How to fix Sony VCR when playback picture does not appear?
If the playback picture doesn't appear on your Sony VCR, ensure your TV is set to the correct video channel or video input if you're using a monitor. Try adjusting the tracking using the $/4 TRACKING buttons. If the video heads are dirty, clean them using a Sony video head cleaning cassette. Avoid wet-type cleaning cassettes.
Why is my Sony SLV-T2000MN remote commander not working?
If your Sony VCR's remote commander isn't working, ensure you're pointing it directly at the remote sensor on the VCR. Replace all batteries with new ones if they are weak. Also, verify that the COMMAND MODE selectors on both the VCR and the remote commander are set to the same positions. Ensure that your TV’s code number is set correctly.
What to do if Sony SLV-T2000MN tape starts playing as soon as it is inserted?
If your Sony VCR tape starts playing immediately upon insertion, ensure the tape isn't at its end. Select the correct source with the INPUT SELECT button, choosing a programme position for TV programmes or “L1” or “L2” for other equipment. Verify that the clock is set, a tape has been inserted, and that the safety tab of the VHS tape has not been removed. Also, check that no timer recording programmes are set, and that your timer settings haven't already passed the current time. Ensure the decoder and satellite tuner are turned on. If the clock stops when the VCR is disconnected from the mains for more than one hour, reset the clock and timer.
Why does my Sony SLV-T2000MN VCR sound unstable or has an echo?
If you're experiencing unstable or echoing sound with your Sony VCR, and you're playing a tape with the same sound recorded on both hi-fi and normal sound tracks, make sure the VHS AUDIO MIX option in the SET UP MENU is set to OFF. Ensure your TV is set to the correct video channel, or video input if using a monitor. If the VCR is connected to the TV using only the aerial cable, ensure the RF MODULATOR option in the SET UP MENU is set to ON. Adjust the TV aerial. If the safety tab of the VHS tape has been removed, cover the tab hole. Check that the safety tab of the VHS has not been removed, or that the safety switch of the 8 mm tape has not been slid to show the red portion.
How to fix Sony VCR ON/STANDBY switch not functioning?
If your Sony VCR's ON/STANDBY switch isn't working, ensure the mains lead is securely connected.
What to do if Sony VCR power is on but the VCR does not operate?
If your Sony VCR isn't operating even when the power is on, it might be due to moisture condensation. Turn the power off, unplug the mains lead, and let the VCR dry for over one hour. Also, the clock stops if the VCR is disconnected from the mains for more than one hour, reset the clock (and timer).
What to do if Sony VCR tape cannot be inserted?
If your Sony VCR tape cannot be inserted, check that a tape isn't already in the tape compartment.
How to fix Sony SLV-T2000MN picture rolls vertically during picture search?
If the picture rolls vertically during picture search on your Sony VCR, adjust the vertical hold control on the TV or monitor.
To Next Page
General
