Need help?Do you have a question about the Sony ST-RV55ES and is the answer not in the manual?
Connect front, rear, center speakers, and subwoofer to the receiver's terminals.
Configure speaker placement and room characteristics for surround sound.
Set speaker size parameters (Large/Small) and configure bass redirection.
Adjust speaker distances for front, center, and rear channels for optimal timing.
Balance speaker levels using test tones for a consistent listening experience.
Choose from various pre-programmed sound modes for different audio sources.
Adjust surround parameters like effect level, wall type, reverberation, and LFE.
Find solutions for common operational issues and problems with the receiver.
Connect front, rear, center speakers, and subwoofer to the receiver's terminals.
Configure speaker placement and room characteristics for surround sound.
Set speaker size parameters (Large/Small) and configure bass redirection.
Adjust speaker distances for front, center, and rear channels for optimal timing.
Balance speaker levels using test tones for a consistent listening experience.
Choose from various pre-programmed sound modes for different audio sources.
Adjust surround parameters like effect level, wall type, reverberation, and LFE.
Find solutions for common operational issues and problems with the receiver.
General| Input sensitivity | 150 mV (line) |
|---|---|
| Speaker load impedance | 4 - 16 ohms |
| Tuning range | FM: 87.5 - 108 MHz |
| Frequency response | 10Hz to 100kHz |
| Dimensions | 430 x 150 x 360mm |
| Power output | 100 W per channel (8 ohms, 20 Hz - 20 kHz, 0.09% THD) |
To Next Page
