Sony STR-DA4ES - Safety and Compliance Information; General Safety Precautions; Electrical Safety and FCC Compliance

Power with Precision Inside this 44 pound behemoth lies a
sonic dream made into reality. Attention to detail is represented
within every element of the design. It is within the amplifier where
form truly meets function. The STR-DA4ES employs unique con-
struction elements to ensure purity with power.The design used to
create the amplifier within the STR-DA4ES is known as a “horizon-
tally” opposed chassis. The output stage of the receiver is built with
the utmost regard to purity of output. Left and Right signal ele-
ments are opposed channel by channel on the two separate
heatsinks. Even the heatsinks themselves have been redesigned to
eliminate resonance introduced into the output transistors in a
design known as Sfin. This attention to detail is typically only seen
in the world of high-end separates. Now the quality separates can
be realized within one chassis.
ADDITIONAL FEATURES
KEY TECHNOLOGY
Product Information
M D / DA TT A PE P H O N O
IN OUT IN OUT IN
SIGNAL GND
U
FRONT SURROUND CENTER
SUB WOOFERSUB WOOFER
L
L
R
L
R
R
AUDIO
IN
VIDEO
IN
VIDEO
IN
AUDIO
IN
M U LTI CHANN EL I N P U T 1 M U LTI CHANN EL I N P U T 2
FRONT SURROUND SURR BACK CENTER
VIDEO
OUT
TV/SAT IN DVD/LD IN MONITOR OUT
C O M PO N E N T VI D EO
Y
R
B /B-Y
P
R /R-Y
75Ω COAXIAL
FM
AM
U
AN TE NNA
CD /S ACD
IN
ND / D A T
O P T I CA L
O U T
I R
O U T 1
M A I N
R
OO M
2 ND
R
OO M
I R
O U T 2
I R I N
M D / D A T
O P T I CA L
I N
T V / S A T
O P T I CA L
I N
D
V D / L D
O P T I CA L
I N
C D / S AC D
C O A X I A L
I N
D
V D / L D
C O A X I A L
I N
C D / S AC D
O P T I CA L
I N
D IGIT A L
I R R EMOTE
T R IGGE R
A SSIG NAB LE
R S 232C
OUTIN STATUS IN
S2 VIDEO
IN
S2 VIDEO
IN
S2 VIDEO
OUT
TV/S A T D V D /L D
MO N ITO R
O U T
AC O U TLET
I M P E D A N C E U S E 4 - 16 Ω
OUT IN OUT IN
OUT IN OUT IN
L
R
VIDEO VIDEO
AUDIO AUDIO
SUB WOOFER
CENTER
VIDEO OUT
VARIABLE
AUDIO
OUT
P R E O U T
FRONT SURROUND SURR BACK
C T R L
A1
2ND
R
OOM
OUT IN OUT
OUT
IN
S2 VIDEO
CONTROL S
S2 VIDEO
VI D EO 2 VI D EO 1
L R
A
B
L R
L R
–
+
–
+
–
+
–
+
–
+
–
+
–
+
–
+
F R O N T
S URR O UND
C E N T E R
S URR BACK
SPE AK E R S
IMPE DANC E SELE C TO R
4 Ω 8 Ω
–
+
Specifications
Amplifier Section
• Multi-Channel Mode:
110W x 7, 0.05% THD
• Stereo Mode (2 Channel):
110 Watts Per Channel x 2
8 ohms, 20 - 20kHz, 0.05%
THD
• Input Sensitivity/Impedance:
Phone: 2.5mV/50 kOhm
Line (CD): 150mV/50 kOhm
• Frequency Response (2 -
20kHz):
Phono: RIAA ±0.5dB
Line (CD): 10Hz-100kHz
+0.5/-2db
• S/N Ratio (IHF-A Network):
Phono: 86dB
Line (CD): 100dB
• Rec Out Level/Impedance:
150mV/10 kOhm
• Pre Out Level/Impedance:
Front: 2V/1 kOhm
Center: 2V/1 kOhm
Rear: 2V/1 kOhm
Woofer:2V/1 kOhm
Video Section
• Input Sensitivity/Impedance:
CompositeIn:1Vp-p/75 ohm
S-VideoIn(Y):1Vp-p/75 ohm
S-VideoIn(C):0.286Vp-p/75
ohm
• OutputSensitivity/Impedance:
Composite In:1Vp-p/75 ohm
S-VideoIn(Y):1Vp-p/75 ohm
S-Video In (C): 0.286Vp-
p/75 ohm
General
• Power Requirements:
AC120V, 60Hz
• Power Consumption
(Standby): 1W
• Power Consumption (in
Operation): 420W
Accessories
Supplied Accessories
• Instruction Manual
• RM-LP211 Remote Control
Weights & Measures
• Dimensions (W x H x D):
17" x 6.8" x 18.3"
• Weight: 44 lbs.
STR-DA4ES
ES Receiver
©2002 Sony Electronics Inc. All rights
reserved. Features and specifications are
subject to change without notice.