How to eliminate hum or noise from my Sony STR-DE485?
To eliminate severe hum or noise from your Sony Stereo Receiver, check that the speakers and components are securely connected. Ensure connecting cords are away from transformers or motors, and at least 3 meters from TVs or fluorescent lights. Move your TV away from the audio components. If the plugs and jacks are dirty, wipe them with a cloth slightly moistened with alcohol.
How to improve FM reception on Sony STR-DE485?
To improve FM reception on your Sony Stereo Receiver, use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antenna.
How to enable surround effect on Sony STR-DE485 Stereo Receiver?
To enable the surround effect on your Sony Stereo Receiver, ensure the sound field function is turned on by pressing the MODE button.
How to balance left and right sound on Sony STR-DE485?
To correct unbalanced or reversed left and right sounds on your Sony Stereo Receiver, adjust the balance parameters in the LEVEL menu.
Why is there no sound from my Sony Stereo Receiver?
If there is no sound or only a very low-level sound from your Sony Stereo Receiver, ensure the speakers and components are securely and correctly connected, the receiver and all components are turned on, and the MASTER VOLUME control is not set at VOL MIN. Also, check that headphones are not connected and that the muting function is off by pressing MUTING. If a short circuit activated the protective device, turn off the receiver, fix the short-circuit issue, and then turn it back on.
What to do if the remote does not function with my Sony STR-DE485?
If the remote isn't working with your Sony Stereo Receiver, aim the remote at the remote sensor, ensure the remote's mode matches the receiver's, and that AV2 is selected as the receiver's command mode. Remove any obstructions between the remote and receiver. If the batteries are weak, replace them. Ensure you've selected the correct function on the remote. If the remote is set to operate the TV only, select a source other than TV before operating the receiver.
What to do if RDS does not work on my Sony STR-DE485?
If RDS does not work on your Sony Stereo Receiver, make sure that you’re tuned to an FM RDS station. Try selecting a stronger FM station.
Why is Dolby Digital or DTS multi channel sound not reproduced on my Sony STR-DE485?
If Dolby Digital or DTS multi channel sound is not being reproduced on your Sony Stereo Receiver, verify that the playing DVD or other source is recorded in Dolby Digital or DTS format. When connecting a DVD player to the receiver's digital input jacks, check the audio settings of the connected component.
How to fix unbalanced left and right sounds on my Sony STR-DE485?
To fix unbalanced or reversed left and right sounds on your Sony Stereo Receiver, first check that the speakers and components are connected correctly and securely. If the issue persists, adjust the balance parameters in the LEVEL menu.
What to do if there is no picture on the TV screen connected to my Sony STR-DE485?
If there is no picture or an unclear picture on the TV screen connected to your Sony Stereo Receiver, select the appropriate function on the receiver and set your TV to the appropriate input mode. Also, try moving your TV away from the audio components.
General| Impedance | 8 ohms |
|---|---|
| Digital Inputs | 1 Optical |
| Type | Stereo Receiver |
| Audio Channels | 5.1 |
| Video Connections | Composite |
| Tuner Type | AM/FM |
| Frequency Response | 10 Hz - 50 kHz |
| Dimensions | 430 x 145 x 298 mm |
| Weight | 17.6 lbs |
| Dimensions (alternate) | 17.1 x 5.6 x 13.8 inches |
| Weight (alternate) | 17.6 lbs |
| Outputs | 2 Audio, 1 Video |
To Next Page
