How to fix recording issues on Sony STR-DE485?
If you're experiencing recording issues with your Sony Stereo Receiver: * Check that the components are connected correctly. * Select the source component using the function buttons. * Ensure INPUT MODE is set to 'ANALOG' when recording from a digital component connected to the analog MD/TAPE terminals.
How to improve FM reception on Sony STR-DE485?
To improve FM reception on your Sony Stereo Receiver, use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antenna.
How to enable surround effect on Sony STR-DE485 Stereo Receiver?
To enable the surround effect on your Sony Stereo Receiver, ensure the sound field function is turned on by pressing the MODE button.
How to balance left and right sound on Sony STR-DE485?
To correct unbalanced or reversed left and right sounds on your Sony Stereo Receiver, adjust the balance parameters in the LEVEL menu.
Why is there no sound from my Sony Stereo Receiver?
If there is no sound or only a very low-level sound from your Sony Stereo Receiver, ensure the speakers and components are securely and correctly connected, the receiver and all components are turned on, and the MASTER VOLUME control is not set at VOL MIN. Also, check that headphones are not connected and that the muting function is off by pressing MUTING. If a short circuit activated the protective device, turn off the receiver, fix the short-circuit issue, and then turn it back on.
What to do if my Sony STR-DE485 Stereo Receiver has no sound?
If your Sony Stereo Receiver isn't producing sound, or the sound is very low, try these steps: * Ensure speakers and components are securely and correctly connected. * Verify the receiver and all components are powered on. * Check that the MASTER VOLUME control is not set at VOL MIN. * Deactivate muting by pressing the MUTING button. * Disconnect any headphones. * If a short circuit activated the receiver's protective device, turn off the receiver, resolve the short-circuit, and then power it on again.
What to do if the RDS information that you want does not appear on my Sony Stereo Receiver?
Contact the radio station to check if they provide the RDS service you are looking for. If they do, the service may be temporarily unavailable on your Sony Stereo Receiver.
Why is there no sound from the active sub woofer of my Sony STR-DE485 Stereo Receiver?
There is no sound output from the SUB WOOFER terminal depending on the sound field of your Sony Stereo Receiver.
How to fix unbalanced left and right sounds on my Sony STR-DE485?
To fix unbalanced or reversed left and right sounds on your Sony Stereo Receiver, first check that the speakers and components are connected correctly and securely. If the issue persists, adjust the balance parameters in the LEVEL menu.
What to do if there is no picture on the TV screen connected to my Sony STR-DE485?
If there is no picture or an unclear picture on the TV screen connected to your Sony Stereo Receiver, select the appropriate function on the receiver and set your TV to the appropriate input mode. Also, try moving your TV away from the audio components.
Procedures for ensuring safety after service, including AC leakage testing.
Mapping model numbers and warning about safety-critical components.
Instructions for operating the unit using the RM-U306 remote control.
Procedures for factory preset reset, sound field clear, and AM channel step selection.
Block diagrams illustrating signal flow for Tuner/Audio, Digital, Video/Display, and Power sections.
Detailed schematics for Main, Digital, Video, Display, and Power sections.
General| Impedance | 8 ohms |
|---|---|
| Digital Inputs | 1 Optical |
| Type | Stereo Receiver |
| Audio Channels | 5.1 |
| Video Connections | Composite |
| Tuner Type | AM/FM |
| Frequency Response | 10 Hz - 50 kHz |
| Dimensions | 430 x 145 x 298 mm |
| Weight | 17.6 lbs |
| Dimensions (alternate) | 17.1 x 5.6 x 13.8 inches |
| Weight (alternate) | 17.6 lbs |
| Outputs | 2 Audio, 1 Video |
To Next Page
