SERVICE MANUAL
Sony Home Entertainment &
Sound Products Inc.
SPECIFICATIONS
MULTI CHANNEL AV RECEIVER
9-896-382-04
2020K33-1
©
2020.11
US Model
Canadian Model
STR-DN1080/ZA810ES
AEP Model
UK Model
Australian Model
Taiwan Model
STR-DN1080
Ver. 1.3 2020.11
Note:
Be sure to keep your PC used for service and
checking of this unit always updated with the
latest version of your anti-virus software.
In case a virus aff ected unit was found during
service, contact your Service Headquarters.
Supplied Accessories
Remote control (1)
R03 (size AAA) batteries (2)
FM wire antenna (aerial) (1)
Calibration microphone (1)
AUDIO POWER SPECIFICATIONS
(STR-DN1080)
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(USA models only)
With 6 ohm loads, both channels driven, from
20 Hz – 20,000 Hz; rated 100 watts per
channel minimum RMS power, with no more
than 0.09% total harmonic distortion from
250 milliwatts to rated output.
Amplier section
1)
Minimum RMS Output Power
(6 ohms, 20 Hz – 20 kHz, THD 0.09%)
100 W + 100 W
Stereo Mode Output Power
(6 ohms, 1 kHz, THD 0.9%)
120 W + 120 W
Surround Mode Output Power
2)
(6 ohms, 1 kHz, THD 0.9%)
165 W per channel
1)
Measured under the following conditions:
2)
Reference power output for front, center,
surround and surround back speakers. Depending
on the sound eld settings and the source, there
may be no sound output.
Frequency response
Analog
10 Hz – 100 kHz, +0.5/–2 dB (with sound
eld and equalizer bypassed)
Input
Analog
Sensitivity: 500 mV/50 kilohms
S/N
3)
: 105 dB (A, 500 mV
4)
)
Digital (Coaxial)
Impedance: 75 ohms
S/N: 100 dB (A, 20 kHz LPF)
Digital (Optical)
S/N: 100 dB (A, 20 kHz LPF)
Output (Analog)
ZONE 2
Voltage: 2 V/1 kilohm
SUBWOOFER
Voltage: 2 V/1 kilohm
Area Power requirements
USA, Canada, Taiwan 120 V AC, 60 Hz
Oceania, Europe 230 V AC, 50 Hz
Equalizer
Gain levels
±10 dB, 1 dB step
3)
INPUT SHORT (with sound eld and equalizer
bypassed).
4)
Weighted network, input level.
FM tuner section
Tuning range
USA and Canadian models:
87.5 MHz – 108.0 MHz (100 kHz step)
Other models:
87.5 MHz – 108.0 MHz (50 kHz step)
Antenna (aerial)
FM wire antenna (aerial)
Antenna (aerial) terminals
75 ohms, unbalanced
Video section
Inputs/Outputs
Video:
1Vp-p, 75ohms
HDMI Video
Resolution
480p/60 Hz
576p/50 Hz
720p/60 Hz, 50 Hz, 30 Hz, 24 Hz
1080i/60 H
z, 50 Hz
1080p/60 Hz, 50 Hz, 30 Hz, 25 Hz, 24 Hz
4K/60 Hz*, 50 Hz*, 30 Hz, 25 Hz, 24 Hz
* VIDEO 1 supports YCbCr 4:2:0 8 bit only
Support
HDCP2.2, HDR (HDR10, Hybrid Log-Gamma,
Dolby Vision), 3D, Deep Color, ITU-R
BT.2020, eARC/ARC
iPhone/iPad/iPod section
BLUETOOTH technology works with iPhone 7,
iPhone 7 Plus, iPhone SE, iPhone 6s, iPhone 6s
Plus, iPhone 6, iPhone 6 Plus, iPhone 5s, iPhone
5c, iPhone 5, iPhone 4s, and iPod touch (5th and
6th generation.)
AirPlay works with iPhone, iPad, and iPod touch
with iOS 4.3.3 or later, Mac with OS X Mountain
Lion or later, and PC with iTunes 10.2.2 or later.
You can use “SongPal” app with this receiver via
BLUETOOTH or network connection.
iPhone/iPad/iPod playback via (USB) port is
not possible.
USB section
(USB) port:
Type A (For connecting USB ash drive)
Maximum current
1 A
Network section
Ethernet LAN
100BASE-TX
Wireless LAN
Compatible standards:
IEEE 802.11 a/b/g/n
Security:
WPA/WPA2-PSK, WEP
Radio frequency:
2.4 GHz, 5 GHz
BLUETOOTH section
Communication system
BLUETOOTH Specication version 4.1
Output
BLUETOOTH Specication Power Class 1
Maximum communication range
Line of sight approx. 30 m (98.4 feet)
1)
Frequency band
2.4 GHz band (2.4000 GHz – 2.4835 GHz)
Modulation method
FHSS (Freq Hopping Spread Spectrum)
Compatible BLUETOOTH proles
2)
A2DP 1.2 (Advanced Audio Distribution
Prole)
AVRCP 1.5 (Audio Video Remote Control
Prole)
Supported Codecs
3)
SBC
4)
, AAC, LDAC
Transmission range (A2DP)
20 Hz – 40,000 Hz (LDAC sampling
frequency 96 kHz with 990 kbps
transmission)
20 Hz – 20,000 Hz (Sampling frequency
44.1 kHz)
1)
The actual range will vary depending on factors
such as obstacles between devices, magnetic
elds around a microwave oven, static electricity,
cordless phone, reception sensitivity, antenna’s
performance, operating system, software
application, etc.
2)
BLUETOOTH standard proles indicate the
purpose of BLUETOOTH communication between
devices.
3)
Codec: Audio signal compression and conversion
format
4)
Subband Codec
General
Power requirements
Power consumption
240 W
European models
Standby mode: 0.4 W
(When [Control for HDMI], [Standby
Through], [Bluetooth Standby], and all
zone power are set to [O].)
Bluetooth Standby mode: 1.5 W
(When [Bluetooth Standby] is set to
[On], and [Control for HDMI], [Standby
Through], and all zone power are set to
[O].)
Networked standby (all wired network
ports are connected, all wireless
network ports are activated): 1.5 W
Other models
Standby mode: 0.4 W
(When [Control for HDMI], [Standby
Through], [Remote Start], [Bluetooth
Standby], [Network Standby], and all
zone power are set to [O].)
Bluetooth Standby mode: 2.5 W
(When [Bluetooth Standby] is set to
[On], and [Control for HDMI], [Standby
Through], [Remote Start], [Network
Standby], and all zone power are set to
[O].)
Dimensions (width/height/depth) (Approx.)
430 mm × 156 mm × 331 mm (17 in ×
6 1/4 in × 13 1/8 in) including projecting
parts and controls
Mass (Approx.)
9.1 kg (20 lb 1 oz) (USA, Canadian and
Taiwan models)
9.7 kg (21 lb 6 oz) (European and Oceanian
models)
Design and specications are subject to change
without notice.
Area Power requirements
120 V AC, 60 HzUSA, Canada, Taiwan
Oceania 230 V AC, 50 Hz
Europe 230V AC, 50/60Hz
Operating frequency and maximum output
power (for European models)
Wireless LAN/BLUETOOTH
Wireless LAN
NFC
Operating
frequency
Maximum output
power
2400 - 2483.5 MHz
Operating
frequency
Maximum output
power
5150 - 5250 MHz
5250 - 5350 MHz
5470 - 5725 MHz
5725 - 5850 MHz
≤ 20.0 dBm
≤ 23.0 dBm
≤ 20.0 dBm
≤ 20.0 dBm
≤ 14.0 dBm
Operating
frequency
Maximum output
power
13.56 MHz < 60 dBμA/m at 10 m
STR-DN1080/ZA810ES
Photo: STR-DN1080
– Continued on next page –
SYSSET
2020/11/1721:24:35(GMT+09:00)
To Next Page
Need help?
General
