Sony TA-AV58 Service Manual

TA-AV581
AEP Model
E Model
Australian Model
SERVICE MANUAL
INTEGRATED AV AMPLIFIER
MICROFILM
Manufactured under license from Dolby Laboratories
Licensing Corporation.
“DOLBY” and the double-D symbol a and “Pro
Logic” are trademarks of Dolby Laboratories
Licensing Corporation.
SPECIFICATIONS
Amplifier section
European models:
(FRONT)
DIN power output
100 W + 100 W (at rear/center/
woofer off at 1 kHz, 8 Ω)
Continuous RMS power output
120 W + 120 W (at rear/center/
woofer off at 1 kHz, 10%
T.H.D., 8 Ω)
80 W/ch (at SURROUND ON
at 1 kHz, 10% T.H.D., 8 Ω)
(REAR) 50 W (at front/center/woofer
off at 1 kHz, 8 Ω)
(CENTER) 50 W (at front/rear/woofer off
at 1 kHz, 8 Ω)
(WOOFER) 80 W (at front/rear/center off
at 40 Hz, 4 Ω)
Other models:
Peak music power output
1900 W (total)
(FRONT)
Continuous RMS power output
100 W + 100 W (at rear/center/
woofer off at 1 kHz, 10%
T.H.D., 8 Ω)
(REAR) 50 W (at front/center/woofer
off at 1 kHz, 8 Ω)
(CENTER) 50 W (at front/rear/woofer off
at 1 kHz, 8Ω)
(WOOFER) 80 W (at front/rear/center off at
40 Hz, 4 Ω)
Inputs
PHONO (phono jacks):
sensitivity 2.5 mV,
impedance 50 kΩ
CD (phono jacks):
sensitivity 400 mV,
impedance 50 kΩ
TUNER, TAPE, VIDEO1,2 (phono jacks):
sensitivity 250 mV,
impedance 50 kΩ
Outputs
TAPE REC OUT, VIDEO 1 (phono jacks):
voltage 250 mV,
impedance 1 kΩ
PHONES (stereo phone jack):
accepts low and high
impedance headphones
TONE ± 10dB at 100 Hz and 10 kHz
General
Power requirements
European, Australian and Singaporean models:
230 V AC, 50/60 Hz
Other models: 110-120 V AC or
220-240 V AC, 50/60 Hz
(adjustable with the voltage
selector)
Power consumption
180 W
AC outlets 3 switched, total 100 W max.
Dimensions (w/h/d)
Approx. 430 × 160 × 355 mm
Mass Approx. 8.5 kg
Supplied accessories
Remote RM-U581 (1)
Sony SUM-3 (NS) batteries (2)
Design and specifications are subject to change
without notice.
• This set is the amplifier
section in SEN-T581.

Sony TA-AV58 Specifications

General

Brand	Sony
Model	TA-AV58
Category	Amplifier
Language	English

Summary

SERVICE MANUAL

Specifications

Details technical specifications of the amplifier section.

TEST MODE

Service Mode Sequence

Describes the sequence to enter different service modes.

GENERAL

Control Location and Function

Identifies and explains front and rear panel controls and connectors.

DIAGRAMS

Circuit Boards Location

Illustrates the physical location of various circuit boards within the unit.

Display Section Wiring

Shows the printed wiring layout for the display board and associated components.

Display Section Schematic

Provides the schematic diagram for the display section.

Power Section Wiring

Displays the printed wiring layout for the power section and associated boards.

Power Section Schematic

Presents the schematic diagram for the power section of the amplifier.

Main Section Wiring

Shows the printed wiring layout for the main board.

Main Section Schematic (Part 1)

Part one of the schematic diagram for the main section.

Main Section Schematic (Part 2)

Part two of the schematic diagram for the main section.

IC Pin Function Descriptions

Details the pin functions for IC401 on the display board.

IC Block Diagrams

Shows the block diagram for IC300 (LV1041M) on the main board.

EXPLODED VIEWS

Front Panel Assembly

Exploded view of the front panel assembly and its parts.

Chassis Assembly

Exploded view of the chassis assembly and its major components.

ELECTRICAL PARTS LIST

Display Section Parts

Lists electrical components for the display section.

Display, HP, Main Parts

Lists electrical components for display, HP, and main sections.

Main Section Parts (1)

Lists main section components.

Main Section Parts (2)

Lists main section components.

Main Section Parts (3)

Lists main section components.

Main Section Parts (4)

Lists main section components.

Main, Outlet, Power, Rear SP Parts

Lists parts for main, outlet, power, and rear speaker sections.

SW, Trans 1, Trans 2, Vol Parts

Lists parts for SW, Trans 1, Trans 2, and Vol boards.