Sony TA-F606ES Service Manual

SERVICE MANUAL
TA-FGOGES
US Model
Canadian Model
SPECIFICATIONS
Audio Power Specifications
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION :
With 8-ohm loads, both channels driven, from
20-20,000 Hz ; rated 80 watts per channel
minimum RMS power, with no more than
0.03 % total harmonic distortion from 250
milliwatts to rated output.
With 4-ohm loads, both channels driven, from
20-20,000 Hz ; rated 100 watts per channel
minimum RMS power, with no more than
0.05 % total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
Power band 8 ohms, _
width
THD
0.05
%
10
Hz
—
100
kHz
at
40
W
0.008 %
0.008 %
Dynamic power
8 ohms at 10 w
output
Total harmonic
distortion
4 ohms, at rated
output
Intermodulation
| (IM) distortion
60 Hz: 7 kHz=
4:1
6 ohms, at rated,
output
8 ohms, at rated
output
Damping 8 ohms, at 1 kHz | 80
network A,
8 ohms
Residual noise less than 110 pV
PHONO MM
(20 Hz — 20 kHz)
RIAA equaliaztion
curve + 0.2 dB
Frequency
response
TUNER, CD
TAPE 1, 2, 3,
DIRECT IN
2 Hz — 200kHz *3dB
— Continued on next page —
INTEGRATED STEREO AMPLIFIER
ON Y.

Sony TA-F606ES Specifications

General

Type	Integrated Amplifier
Total Harmonic Distortion (THD)	0.008%
Damping Factor	100
Frequency Response	10 Hz - 100 kHz
Signal-to-Noise Ratio	100 dB
Speaker Load Impedance	4Ω - 16Ω
Dimensions	430 x 140 x 360 mm
Power Output	100 W + 100 W (8 ohms)

Summary

Specifications

Audio Power Specifications

Details on power output and total harmonic distortion for 8 and 4-ohm loads.

Amplifier Section Technical Data

Technical data for amplifier section including power band width, dynamic power, distortion, and damping.

General Information

System and Power Specifications

Covers system type, power requirements, consumption, AC outlets, dimensions, and mass.

Front Panel Controls and Functions

Detailed explanation of each button, knob, and indicator on the amplifier's front panel.

Safety Check-Out

Leakage Test Procedure

Outlines the AC leakage test methods, limits, and equipment for safety compliance.

Hooking Up the System

Connection Diagrams and Notes

Provides essential notes and visual diagrams for connecting external audio sources and speakers.

Electrical Adjustments

Bias Adjustment Procedure

Step-by-step guide for adjusting the bias on the main board.

Diagrams and Schematics

System Controller Details

Details pin functions of the M50720-358SP system controller IC.

Semiconductor Lead Layouts

Visual representation of semiconductor pin configurations for various components.

Circuit Board Locations and IC Block Diagrams

Illustrates board placement and functional block diagrams for key ICs.

System Block Diagram

High-level overview of the unit's functional blocks and signal flow.

Printed Wiring Board Layouts - Control Sections

PCB layout for control, input, selector, and volume sections.

Schematic Diagram - Control Sections

Detailed circuit schematic for control, input, and selector sections.

Schematic Diagram - EQ, Main, SP Sections

Circuit schematic for equalizer, main, and speaker sections.

Printed Wiring Board Layouts - EQ, Main, SP

PCB layouts for equalizer, main, and speaker sections.

Exploded Views

Front Panel Assembly

Exploded view showing parts and assembly of the front panel.

Sub Chassis Assembly

Exploded view showing parts and assembly of the sub chassis.

Main Chassis Assembly

Exploded view showing parts and assembly of the main chassis.

Electrical Parts List

ABJ and Control Board Components

List of electrical parts for ABJ and control boards.

Control Section Components

Detailed list of resistors, variable resistors, relays, switches, and thermistors for control functions.

EQ Board Components

List of capacitors, connectors, diodes, ICs, and transistors for the equalizer board.

EQ, HP, and Input Board Components

Parts for equalizer, headphone, and input boards, including resistors, switches, thermistors, and jacks.

Input, IPJ, and Main Board Components

Parts list for input, IPJ, and main boards, featuring capacitors, connectors, diodes, ICs, and transistors.

Main, Outlet, RYJ, and Selector Board Components

Components for main, outlet, RYJ, and selector boards, including resistors, connectors, diodes, and ICs.

Selector, SP, and Vol Board Components

Parts for selector, speaker (SP), and volume (VOL) boards, including switches, terminals, capacitors, diodes, resistors, and relays.

Vol LED Board Components and Hardware

Parts list for the volume LED board, miscellaneous items, accessories, and hardware.