EasyManua.ls Logo

Sony TA-V606 - Safety Component Warning

Sony TA-V606
31 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
– 2 –
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK ! OR DOTTED LINE WITH
MARK ! ON THE SCHEMATIC DIAGRAMS AND IN THE PARTS
LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE
PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR IN
SUPPLEMENTS PUBLISHED BY SONY.
TABLE OF CONTENTS
Specifications ........................................................................... 1
1. GENERAL
Location and Function of Controls .................................... 3
2. DIAGRAMS
2-1. IC Pin Function........................................................... 5
2-2. Circuit Boards Locations ............................................ 7
2-3. Printed Wiring Boards – Surround Section – ............. 8
2-4. Schematic Diagram – Surround Section –............... 11
2-5. Schematic Diagram – AMP Section – ..................... 15
2-6. Printed Wiring Boards – AMP Section –.................. 19
2-7. Printed Wiring Boards – Display Section – ............. 23
2-8. Schematic Diagram – Display Section – .................. 27
3. EXPLODED VIEWS
3-1. Front Panel Section................................................... 32
3-2. Chassis Section ......................................................... 33
3-3. Back Panel Section ................................................... 34
4. ELECTRICAL PARTS LIST ........................................ 35
Video section
Inputs 1 Vp-p 75 ohms
Outputs 1 Vp-p 75 ohms
General
System Preamplifier section :
Low-noise NF type equalizer
Power amplifier section :
Pure-complementary SEPP
Power requirements AEP, Singapore, Malaysia model :
230 V AC, 50/60Hz
UK model : 240 V AC, 50/60Hz
Chinese model : 220 V AC, 50/60Hz
Power consumption 240W
AC outlets EXCEPT Chinese model :
1 switched, maximum 100W
Chinese model : 2 switched, total 100 W
Dimensions 430 x 155 x 350 mm
including projecting parts and controls
Mass (Approx.) 9.8 kg
Supplied accessories Remote commander (remote) RM-U501 (1)
Size AA (R6) batteries (2)
Design and specifications are subject to change without notice.

Related product manuals