Rechargeable Battery Pack BP-23
outonat aeeessor
This battery pack is good for
approx.
100 discharge and
recharge cycles. Before using, charge the battery com-
pletely. The Power Adapter
&
Charger AC-9 is used for
charging.
How to charge:
Install the BP-23 in the battery case
instead of the supplied battery holder. (The installation of
the BP-23 is the same as that of the supplied battery
holder.) Connect the recorder to an AC outlet, using the
Power Adapter & Charger for about
4
hours at nominal
operating voltage.
o
Fully charged BP-23 permits approx.
3
hours of continu-
ous recording.
o
If the pointer of the record/battery indicator stays in the
white zone during playback, recharge the battery as
described above.
o
The recorder can be operated while charging, though
more charging time is needed.
o
To avoid over-charging, be sure to remove the power
adaptor when charging is completed.
".
Car boat batter
With the use of the SONY Car Battery Cord DCC-126
(optional accessory). the recorder will operate on a 12V
car/boat battery through a cigarette lighter socket of your
car or boat. For details. refer to the instructions for the
DCC-126.
t
Cigarette lighter socket
battery case
BP-23
10
11
To Next Page
