Basic Operations
Basic Operations
3-856-130-11(1)
5
EN
4
Press ·.
The deck starts playing. Adjust the volume on the amplifier.
Do not press POWER or § EJECT while the tape deck is
operating. If you do so, the tape may be damaged.
To play back Set DIRECTION to
PRr
§
0
)
REC MUTE
PAUSE
RESET
REC
p
ª·
OFF
L R
MPX
FILTER
DOLBY NR BALANCE
AUTO CAL
EJECT
POWER
REC LEVEL
PHONES
0
1
2
3
4
5
6
7
8
9
10
MEMORY
CC
BB
0 AMS )
A
Å
DIRECTION
a
2
34
Playing a Tape
Basic Operations
• See page 4 for hookup
information.
1
Turn on the amplifier and select the tape deck position.
2
Press POWER, and then press § EJECT.
Insert a cassette and close the cassette holder.
The tape type (I, II, or IV) appears in the display.
* Dolby noise reduction
manufactured under license from
Dolby Laboratories Licensing
Corporation.
“DOLBY” and the double-D
symbol a are trademarks of
Dolby Laboratories Licensing
Corporation.
With the side you want to play
facing you
z To play a tape recorded
with the Dolby NR*
system
Turn DOLBY NR clockwise
to the same position that the
tape was recorded in (B or
C).
Please note that the DOLBY
NR settings with MPX
FILTER (counterclockwise)
are used only during
recording.
z You can connect the
headphones to
PHONES.
3
Set DIRECTION.
One side only A
Both sides Å
Both sides continuously* a
* The deck automatically stops after playing back five times.
To
Press
pStop playing
Start playback from the reverse side ª
Pause P PAUSE. Press the button again to
resume play.
Fast-forward or rewind ) or 0 when the deck is stopped
§ EJECT after stopping playingTake out the cassette
To Next Page
Loading...
