3-856-130-11(1)
8
EN
Advanced Playback Operations
PRr
§
0
)
REC MUTE
PAUSE
RESET
REC
p
ª·
OFF
L R
MPX
FILTER
DOLBY NR BALANCE
AUTO CAL
EJECT
POWER
REC LEVEL
PHONES
0
1
2
3
4
5
6
7
8
9
10
MEMORY
CC
BB
0 AMS )
A
Å
DIRECTION
a
M
00 00
RESET MEMORY
0ª / ·)
Locating a Track (Multi-AMS/
Auto Play/Memory Play)
You can locate the following/previous tracks (Multi-
AMS: Automatic Music Sensor) or the beginning of a
tape quickly. You can even locate a specific point
anywhere on a tape.
Note
Check the direction indication of the tape. When you locate
a track on the reverse side (when “ ª” lights up), press the
button(s) in the parentheses.
To locate
the beginning of the next or
succeeding tracks (Multi-
AMS*)
the beginning of the current
track (Multi-AMS*)
the beginning of the
preceding tracks(Multi-
AMS*)
Press
a particular point on a tape
(Memory Play)
the beginning of a tape
(Auto Play)
MEMORY repeatedly until
“M” appears in the display.
Find the point you want, and
press RESET to reset the tape
counter and to memorize the
point.
To locate the memorized
point, press 0(or )) while
holding down ·. (Press 0 or
) only to stop at “00 00.”)
MEMORY repeatedly until
“M” disappears in the
display. Then press 0(or
)) while holding down
·(or ª).
0(or )) as many times as
you want while playing. For
example, to locate 2 tracks
behind, press three times.
0(or )) once while
playing
)(or 0) as many times as
you want while playing.
For example, to locate 2 tracks
ahead, press twice.
*You can use the Multi-AMS to locate up to the 30th track
after or before the current track.
What happens during Multi-AMS operation
When Multi-AMS is operating, “PLAY” appears. And each
time the deck detects a blank space, the indicated number
decreases by one. After locating the beginning of the
specified track, the counter indication appears again and the
deck starts playing the track.
)
[ ][]
0
[ ] [ ]
0)
: Beginning of track
Previous
track
Current
track
Next
track
Notes
•The Multi-AMS function may not work correctly if:
— the blank space between tracks is less than 4 seconds
long.
— the signal strength of the left and right channels are
very different.
—there is a passage of low frequencies or very low
volume within a track.
•Since the counter is not a digital clock, it will differ from
the actual elapsed playback or recording time.
•Even if DIRECTION is set to a, the deck stops when the
current side reaches the end during AMS operation.
Tape direction indicator: ·
To Next Page
Loading...
