Sony TC-S1 - Chapter 4 Other Operation; Playing Back and Recording Using a Timer

Chapter 4
Other
Operations
10
Chapter 4: Other Operations
| ee a ee
Playing Back and
Recording Using a
Timer
By using an optional timer, you can record
or play back at a preset time.
Dolby NR setting and direction mode setting
are maintained even if the power is turned off.
TC-S1
Amplifier
- toa
to a mains 4 mains
3 Timer
os
to a mains
1 Prepare the tape deck for playback or
recording.
For Follow steps
playback 1 through 5 on page 5.
recording 1 through 5 on page 7.
After completing the preparations, press
Wl to set the tape deck to stop mode.
Make sure to close the tray completely.
2 set the input selector on the amplifier.
For The input selector
playback tape position
recording source to be recorded
3 set the timer.
Power to the tape deck turns off.
4 set TIMER to PLAY or REC.
Playback or recording will start at the
preset time.
Note
After timer-activated recording has ended, set
the TIMER selector on the tape deck to OFF. If
you leave the TIMER selector at REC, the unit
will automatically start recording the next
time you turn the power on, and recorded
material may be erased.
Check the direction mode indicator
Timer-activated operations start from the side
of the cassette being used when the power was
turned off.
Keep the POWER switch on the unit on
When you set the timer, the power to the tape
deck turns off. You must, however, leave the
POWER switch on to enable timer-activated
operation.