Sony TC-S1 - Inserting a Blank Space During Recording - Record Muting

The CAL indicator flashes continuously
The automatic calibration process has been
interrupted by:
- The end of the tape. Reverse the tape
direction or fastwind to a new position that
allows recording of the test tone.
- Damaged tape or dirty heads. Change the
cassette or clean and demagnetize the heads.
i |
Inserting a Blank
Space During
Recording —Record
Muting
You can use the record muting function
only with the remote commander supplied
with TAE-S1/TA-S2 stereo preamplifier /
integrated stereo amplifier.
The record muting function allows you to
insert a four-second blank between
selections to enable proper AMS operation
(see page 5), or to replace unwanted
recorded material with a blank of any
length.
n Tey
EIS AG ectenass
sly,
PLAY fe — (REC) ~
The REC indicator start flashing. During
this time, no incoming signals are
recorded on the tape.
After four seconds, the REC and H
indicators light up and the unit enters
recording pause mode.
2 Press 1 when you want to resume
recording.
To create a blank longer than four
seconds
Press the O button and keep it pressed for
as long as desired. After four seconds, the
REC indicator flashes at a faster rate. When
you release the O button, the HM indicator
lights up and the unit goes into recording
pause mode.
Press the If button when you want to
resume recording.
Chapter 3: Recording
~ A