15
Recording on a Tape
Recording on both decks
in succession
— Relay Recording
(TC-WE675 only)
You can make a continuous recording that
starts on a cassette in deck A and ends on a
cassette in deck B.
1 Load blank cassettes into both decks.
Make sure that record-protect tabs on the
cassettes have not been removed.
2 Select the Dolby NR (see page 10).
3 Set DIRECTION MODE to RELAY.
4 Press z REC on deck A.
Deck A changes to recording pause.
5 Start playing the program source.
6 Adjust the recording level manually, if
necessary (see page 11).
7 Start recording.
To record from Press
The front side H on deck A
The reverse side h on deck B
To stop Relay Recording
During Press
Recording on deck A x on deck A
Recording on deck B x on deck B
Note
Make sure that H on deck B appears in the display.
If it doesn’t, press H on deck B once; otherwise,
Relay Recording stops when the reverse side of the
cassette in deck B finishes.
Recording the same
source on both decks
— Simultaneous Recording
(TC-WE675 only)
You can record the same source on cassettes in
deck A and B at the same time.
1 Load blank cassettes into both decks.
Make sure that record-protect tabs on the
cassettes have not been removed.
2 Select the Dolby NR (see page 10).
3 Select the side(s) to be recorded on.
To record on Set DIRECTION MODE to
Only one side g
Both sides s
4 Press A+B REC.
Both decks change to recording pause.
5 Start playing the program source.
6 Adjust the recording level manually, if
necessary (see page 11).
7 Select the side you want to start
recording from on both decks.
To record from Press
The front side H
The reverse side h
8 Press X PAUSE on deck B.
Simultaneous Recording starts.
To stop Simultaneous Recording
Press x on both decks.
Tip
During Simultaneous Recording, X PAUSE and W
REC MUTING on deck B control both decks, but not
X PAUSE and W REC MUTING on deck A.
To Next Page
Loading...
