Connecting an antenna/cable TV system with a VCR
To connect your VCR to the TV, first check the model
number of your TV and seleCt the corresponding
connection. For details on connection, see the
instruction manual of your VCR.
In order to operate PIP, a VCR must be connected to
your TV and turned on (KV-27S25/27V25/29RS25/
29RS25C/29V65M/32S25/32TW25/32 V25 only).
Before making the connection, disconnect the AC
power cords of the equipment to be connected.
After making these connections, you will be able to do
the following:
• View the playback of video tapes
• Record one TV program while viewing another
program
• Watch two TV programs at once using PIP
Without a cable box
Antenna cable
VCR
J _']OUT AUDIO VIDEO
Cable _rN ___
VHF/UHF
VHF/UHF_m _
I
VMC-810S/820S
(not supplied)
(Rear of TV)
VIDEO IN
1 2
SVlDEO-
A_
_UDIO OUT
---L
VIDEO (yellow)
AUDIO-L (white)
AUDIO-R (red)
Note
• To connect a monaural VCR, connect the audio output of the
VCR to AUDIO-L (mono) of VIDEO 1 IN on the TV.
To an S video equipped VCR without a cable box
If your VCR has an S video output jack, make the
following connections.
(RearofTV)
Antenna cable
Cable
VHF/UHF
m
VCR
OUT AUDIO VIDEO S VIDEO ]
= m =
Q
Getting Started
VHF/UHF
©
YC-15V/30V
(not supplied)
!
1
RK-74A
(not supplied)
VIDEO IN
1 2
SVlDEO- _
AUD_ OUT
-- AUDIO-L (white)
To Next Page
