KV-27FV15/29FV10/29FV15/29FV15C/29FV15K
— 27 —
6. Write SHUE data 1 step down and SCOL data 2 steps up.
7. Write into the memory by pressing
then .
V1
V2 V3
V4
H. SIZE ADJUSTMENT (HSIZ)
1. Input a monoscope signal.
2. Set to Service Adjustment Mode.
3. Select HSIZ with
and .
4. Adjust with
and for the best Horizontal size.
5. Write into the memory by pressing
then .
H. SIZE
V. SIZE ADJUSTMENT ( VSIZ)
1. Input a monoscope signal.
2. Set to Service Adjustment mode.
3. Select VSIZ with
and .
4. Adjust with
and for the best vertical size.
5. Write into the memory by pressing
then .
V. SIZE
V. POSITION ADJUSTMENT (VPOS)
1.Input a monoscope signal.
2.Set to Service Adjustment Mode.
3.Select VPOS with
and .
4.Adjust with
and for the best vertical center.
5.Write into the memory by pressing
then .
V. POSITION
SUB BRIGHT ADJUSTMENT (SBRT)
1. Set to Service adjustment Mode.
2. Input a gray scale pattern signal.
3. Set the PICTURE to minimum, and BRIGHT to normal.
4. Select SBRT with
and .
5. Adjust SUB BRIGHT level with
and so that the stripe
second from the right is faintly visible.
6. Write into the memory by pressing
then .
white
black
second from the right
SUB CONTRAST ADJUSTMENT (SCON)
1. Input a 75% color-bar signal.
2. Set to VIDEO mode = STANDARD, COLOR = minimum,
PICTURE = 100%.
GON = 0 (OFF), BON = 0 (OFF).
3. Set to Service adjustment Mode and Connect an oscilloscope
pin 1 of CN351 on A Board.
4. Select SCON with
and .
5. Adjust with
and for the 1.90 ± 0.05Vp-p of level.
6. Write into the memory by
then .
White
Black
1.90±
0.05Vp-p
SUB HUE, SUB COLOR ADJUSTMENT (SHUE, SCOL)
1. Input a color bar signal.
2. Set to Service Adjustment Mode and set to
VIDEO mode = STANDARD
PICTURE = 100%
COLOR = 50%
HUE = 50%.
3. Connect an oscilloscope to CN351 Pin 3 of A Board.
4. Select SHUE and SCOL with
and .
5. Adjust with
and for the V1 = V4 (SCOL) and V2 = V3
(SHUE).
To Next Page