Sony Trinitron KV-32V26 - Connecting Specific Equipment

Cable or antenna
Most simple connection. Connection is made
directly from the cable or antenna to the TV.
(Rear of TV)
VHF/UHF
Cable
————P —*)
Cable and antenna
e KV-27S36, 27V36, 29V36C, 29V76M, 32536, 32V36,
34V36C, 35536, 35V36, 35V76, 37V36M only
You may find it convenient to use the
following set up if your cable provider does
not feature local channels that you are able to
receive using an antenna.
(Rear of TV)
BE able AUX
C
SY —*P
(No connection "TO fo s
CONVERTER” in this case)
TO CONVERTER
amt)
VHF/UHF
Antenna cable
Select Cable or ANT mode by pressing ANT on
the remote control.
Connecting a cable box
Some pay cable TV systems use scrambled or
encoded signals that require a cable box* to
view all channels.
(Rear of TV)
VHF/UHF
Cable
*Cable box
Note:
¢ If you will be controlling all channel
selection through your cable box you
should consider using the CHANNEL FIX
feature discussed on page 22.
Cable box and cable
e KV-27S36, 27V36, 29V36C, 29V76M, 32836, 32V36,
34V36C, 35$36, 35V36, 35V76, 37V36M only
Some pay cable TV systems use scrambled or
encoded signals requiring a cable box* only for
certain channels (e.g. HBO, SHOWTIME, etc.).
*Cable
box
(Rear
of
TV)
AUX
i D—€))
bl
ramped TO CONVERTER
channels
iG)
4
‘ (signal)
75-ohm coaxial
cable (not supplied)
—<p)
VHF/UHF
CATV cable
(unscrambled channnels)
For this set up, you can switch between scrambled
channels (through your cable box), and normal
(CATV) channels by pressing ANT on your
remote control.
* Your Sony remote control can be programmed
to operate your cable box (see page 26).
Notes:
e You cannot watch the signal through the
“AUX” input as a window picture when
using Picture-in-Picture (PIP).
* Ifyou are connecting a cable box through
the“AUX” input and would like to switch
between the “AUX” and normal (CATV) input
you should consider using the CHANNEL FIX
feature discussed on page 22.