Sony Trinitron PVM-4300 - Learning Function Notes and Troubleshooting

Using the
Programmable
Remote
Commander
Notes
When
operating equipment
with learned
functions,
the
VTR 1/2/3/MDP
selector
should
be
set to
the same
position as
it was
when the functions
were
memorized.
The LEARN-USE
selector
should be set to
USE.
The
functions of
other equipment
can
be
memorized
by
repeating these steps
for
each of the
positions
of
the
VTR
1/2/3/MDP selector. Use
the
supplied
index sheets by
placing
them on
buttons and writing
the names
of
memorized
functions for
further reference.
The batteries will
last about
half
a
year with
normal
operation. Replace the
batteries
before they
wear
out.
Replace the
batteries
within approximately 30
minutes.
If
not,
the
memorized function on
the buttons may be
erased.
Do
not use the
learning
function for
equipment other
than
audio and video ones.
Be sure to
confirm that
the functions
have been
memorized as a
few of the
functions of
other
manufacturer's
commanders
are not storable
on RM-778.
•
When
you
have
memorized
a
new
function on
a
button,
the
previous function is
cleared automatically.
The
learning function
will not
work
in
the
following
cases:
•
There is
a
fluorescent lamp or
equipment with infrared
rays which emit noise.
->
Move the
commanders away
from them.
•
The
batteries are
exhausted.
->
Replace all the batteries
with new ones.
•
There is an
obstacle between the
commanders, or
the
commanders are not
positioned head to
head and exactly
aligned.
->
Position the
commanders properly.
26