To Next PageTo Next Page
Need help?Do you have a question about the Sony Trinitron PVM-1353 and is the answer not in the manual?
Detailed technical specifications for the PVM-1353MD model.
Section detailing the disassembly procedures.
Section containing exploded views of the unit.
Procedures for leakage testing and finding earth ground.
Identification and description of rear panel connectors.
Mode for advanced settings and adjustments.
Identification and description of front panel controls.
Preparations and methods for entering the service mode.
Required signal levels for composite video and component signals.
Setting AC input voltage and performing landing adjustments.
Procedure for aligning R, G, B dots for convergence.
Procedure for adjusting deflection yoke to reduce misconvergence.
Procedure for adjusting white balance using a color analyzer.
Procedure for confirming the B+ voltage level.
Confirmation of hold-down circuit voltages for safety.
Adjustment points on the A board's component side.
Adjustment points on the A board's conductor side.
Signal levels required for deflection system adjustments.
Adjusting horizontal blanking and picture phase.
Adjusting vertical blanking and vertical deflection section.
Adjustments for horizontal deflection in normal scan mode.
Adjustments for horizontal deflection in under scan mode.
Adjusting horizontal and vertical size in over scan mode.
Adjusting sub-con and sub phase for NTSC and PAL signals.
Adjusting sub chroma and R-Y level for component signals.
Adjusting SMPTE sub color and burst gate pulse width.
Adjusting NTSC phase and B-Y phase for color demodulation.
Adjusting NTSC R-Y level and PAL line crawling.
Adjusting PAL phase (normal) and PAL B-Y phase.
Adjusting PAL chroma and R-Y level.
Checking output lines on the G board.
Block diagram illustrating the overall system architecture.
Schematics and PWB layouts for A board and related components.
General